User Manual for InCarTec models including: 39-IVE-02 Iveco Daily CANbus Steering Wheel Control Interface, 39-IVE-02, Iveco Daily CANbus Steering Wheel Control Interface, CANbus Steering Wheel Control Interface, Steering Wheel Control Interface, Wheel Control Interface, Control Interface, Interface
39-IVE-02 Iveco Daily CANbus steering wheel control interface Compatible vehicles Iveco Daily VI (2014 >) Iveco Daily 7 (2019 >) ONLY MODELS WITH DELPHI DAB RADIO Fiat Ducato (2021 >) ONLY VEHICLES WITH CAN STEERING WHEEL CONTROLS AND ISO CONNECTORS Set the switches The switches on the interface need to be set according to the brand of radio and vehicle model. Open the black box and set the switches. See the tables below and right for the switch settings. Switches 1-4 relate to the brand of head unit and switches 5-8 are vehicle options. Try setting option 1 first, check that if the steering control are operating correctly and that the odometer is not flashing, if this is the case, try other settings. Some cars may have a flashing odometer after installation, in this instance, try the other switch options for that type of car group. Switch 1 2 3 4 Alpine Off On Off Off Kenwood On On Off Off JVC Off Off On Off Clarion Off On On Off Zenec Off Off Off On Sony On Off On On Pioneer Off On On On Chinese/learning On Off Off On 5 6 7 8 Car model On Off Off Off Iveco Daily VI & Fiat Ducato Delphi DAB Radio Set up the patch lead 4 3 2 1 Pioneer and Sony Pin 1 black (base) Pin 2 red (middle) Pin 3 not connected Pin 4 white (tip) 4 3 2 1 Alpine, Clarion and JVC Pin 1 black (base) Pin 2 white (tip) Pin 3 not connected Pin 4 red (middle) 4 3 2 1 JVC, Kenwood and Zenec Pin 1 not connected Pin 2 blue (single wire) Pin 3 not connected Pin 4 not connected 4 3 2 1 Chinese/Learning Pin 1 blue (single wire) Pin 2 not connected Pin 3 not connected Pin 4 blue (single wire) The 4 pin patch lead connector diagrams above are viewed from the wire entry side of the connector. 39-IVE-02 Iveco Daily CANbus steering wheel control interface Green- CAN active Yellow- Ignition output active When connected the green light will indicate that the interface is recognising the vehicles CANbus, and the yellow light will indicate the interface is giving out an ignition power supply. If the green light is not on check the CANbus connections and switch settings. MUTE VOLUME UP VOLUME DOWN Short Press: SOURCE Long Press: PUSH TO TALK Steering Wheel Control Functions ANSWER CALL TRACK UP TRACK DOWN REJECT/END CALL Setting time and date (If required) Press mute and track+ at the same time. The radio will turn off to show time setting mode is active. Use volume + and - to set time and date, use track + and - to move through OPTIONAL FLY LEAD CONNECTIONS: Pink-- Speed Pulse Output Purple/ White-- Reverse Output Green-- Handbrake Output NOTE: The loose purple lead with a terminal can be insulated and ignored in this application. NOTE: Not all vehicles require the red mini-ISO plug to be connected.Microsoft Office Publisher 2007 Microsoft Office Publisher 2007