Instructions for FITHOME models including: JJ-BLE, JJ-BLE Bluetooth Embedded Module, Bluetooth Embedded Module, Embedded Module, Module
FITHOME (Xiamen) Technology Co., Ltd JJBLE Bluetooth Module 2BEFF-JJBLE 2BEFFJJBLE jjble
FITHOME (Xiamen) Technology Co., Ltd.
--%/( --%/(%OXHWRRWKHPEHGGHGPRGXOH
210-229544
Specification
'VVKGXGTIKGTJOTZKXLGIK
(R[KZUUZN VXUZUIUR
Working frequency
modulation mode
ZXGTYSOZZOTMVU]KX
response rate
(R[KZUUZN9VKIOLOIGZOUT<
d3.` -,91-G[YYOGT,XKW[KTI_9NOLZ1K_OTM "J(S J(S
Support service
power dissipation
6KXOVNKXGR;;/*,:39 dS'
working temperature
-20 ~ 70
Voltage
Drive ability
Size
*) < /5"S'3'> S' SS^SS^SS
PA7 10 PA6 09 PA5 08 PA4 07 PA3 06 PA2 05 PA1 04 PA0 03 PB9 02 PB8 01
20 PB0 19 PB1 18 PB3 17 PB4 16 PB5 15 PB6 14 PB7 13 GND 12 VBAT 11 HR/VCC
6/4
4'3+
6(
6(
6'
6'
6'
6'
6'
6'
6'
6'
.8<))
<
<(':
<<
-4*
-4*<
6(
6(
6(
6(
6(
6(
6(
Caution: The user is cautioned that changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
The module in this product is labeled with its own FCC ID No. The FCC ID and is not visible when the module is installed
inside another device. Therefore, the outside of the device into which the module is installed must also display a label
referring to the module. The final end device must be labeled in a visible area with the following: Contains FCC ID: 2BEFF-JJBLE"
4
www.adultpdf.com