Installation Guide for Solar Lighting DiRECT models including: SLDWL01, BLK-WW, SLDWL01-BLK-WW Solar Powered Wall Light, SLDWL01-BLK-WW, Solar Powered Wall Light, Powered Wall Light, Wall Light

Sydney Lighting Solutions

Download Product Instruction Guide

Solar Powered Wall Light - Black – Solar Lighting Direct


File Info : application/pdf, 1 Pages, 320.93KB

PDF preview unavailable. Download the PDF instead.

SLDWL01-BLK only ?v=1741138172
INSTRUCTION GUIDE
Residential Wall Light
Model No. SLDWL01/BLK-WW

PACKAGE CONTENTS
1. 1 x Light Fitting 2. 1 x Packet of fixings
FEATURES
1. Automatic Day/Night Operation 2. On/Off Button 3. 8-10 hours Operation per day 4. Black P.C. Finish
INSTALLATION METHOD
1. Remove contents from packaging
2. Locate desired wall for installation (ensure your desired location will receive maximum direct sunlight throughout the day)
a) Remove 2 grub screws to separate mounting plate from light.
b) Secure mounting plate to wall using appropriate fixing screws.
c) Locate the red On/Off button on the back of the light (which will be in the `OFF' position) and press once to activate automatic day/night operation.
d) Secure light to mounting plate by reinstalling grub screws.
65mm

IMPORTANT NOTES
 Please ensure you place your Solar Panel in a location where it can achieve a minimum of 6HRS DIRECT SUNLIGHT.
 Be aware that on overcast/cloudy days, the solar panel will still charge. However, not as efficiently as a sunny day, so the battery may not reach full capacity. Therefore, your light may turn off earlier than specified.
 It's best not to install these lights underneath a street light, porch light etc. because this may stop the automatic daynight operation triggering and result in your lights not turning on.

TROUBLE SHOOTING

Phenome non
Light won't turn on

Cause
Switch hasn't been turned
on
Battery has run
flat

Inspection Method

Solution

Determine what position the switch is
in

Turn the switch on

Period of rainy or
cloudy weather or
installation site doesn't provide enough direct sunlight

Charge the light in direct
sunlight for 1-2 days then check
again

The light only stays on for a
short amount of time

Low Battery
Battery Failure

1. Bad installation site for the solar panel 2. Dust or leaves are covering the panel 3. Long period of overcast weather

1. Charge the battery in direct sunlight for 1-2
days with the switch off, then
check again 2. Clean the solar panel

1. Access the light and & replace battery 2. Battery has matured

Contact SLD Customer Service to buy new batteries

130mm

LK

150mm

Customer Service Number: 1300 135 911

www.solarlightingdirect.com.au



References

Microsoft Word 2010 Microsoft Word 2010