Instruction Manual for HDR models including: NHS7720, 2ANM3NHS7720, BLE Voice and Infrared Remote Control

FCC-manual

User Manual

Shenzhen Chuangwei-RGB Electronics Co., Ltd. NHS7720 Ble voice & Infrared remote control 2ANM3NHS7720 2ANM3NHS7720 nhs7720

• Google Docs
• Google Drive
• Download [pdf]
• Download Optimized



File Info : application/pdf, 2 Pages, 71.26KB

Document Document

BLE voice & Infrared remote control manual

Infrared mode Infrared protocol:TC9012 Customer code:0x0E0E

Indicator light

0D

0C

81/ 82

Voice VOICE KEY BT unpaired is 81H BT paired is 82H

01 02 03

04 05 06

07 08 09

16 00 0F

LEFT AND HOME KEY

78 42 11 44 46 45

64 43 B5

D5

D6

14 B3 12
15 B4 13
40 61 41 B2 63 4A A0 A1 A2 A3 AD AC AB 67

Bluetooth mode HID USAGE 0x0C

This key Only IR CODE

E2H
221H
93H 61H 88H 63H 89H 65H 8AH 8BH 82H 60H 83H 91H

223H 42H 40H

44H 41H 45H

224H 43H 94H

018EH 25FH

E9H 6FH 9CH EAH BCH 9DH

B4H B0H B3H 98H B1H B7H
69H 6AH 6BH 6CH 8EH 96H 97H A0H

BLE voice & Infrared remote control manual
The remote control has two modes: infrared and Bluetooth.
In the infrared working mode, the key sends the infrared code.The indicator light is red after pressing the key.
In Bluetooth mode (after successful pairing with the TV), press the key to issue the Bluetooth code (except the power key).The indicator light is green after pressing the key. Continue pressing the voice key, start the voice input.Release the voice key and end the voice input.
The pairing keys are HOME and LEFT keys. Press for more than 3 seconds to enter the pairing mode. The red light changes from always on to green flashing.
After the pairing is successful, the green light is always on and goes out after 2 seconds. If the pairing is unsuccessful within 1 minute, automatically exit the pairing mode and the green light goes out.
No operation was performed within 10 seconds and the remote control went to sleep. Press any key to wake up the remote control.
If the remote control has paired before, press LEFT + HOME for 3 seconds to clear the pairing information.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.
FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: This device may not cause interference. This device must accept any interference, including interference that may cause undesired operation of the device.
L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d'Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: 1. L'appareil ne doit pas produire de brouillage; 2. L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.