EZYmount VLM-6800 Assembly Instructions

Please dispose of this packaging in a responsible manner - recycle cardboard/plastic wherever possible.

Important Safety Information

CAUTION: DO NOT EXCEED RATED LISTED WEIGHT. SERIOUS INJURY OR PROPERTY DAMAGE MAY OCCUR!

Maximum Weight Capacity: 70kg (154 lbs)

Maximum Screen Size: 100 inches

Parts List

• For Attaching Brackets to TV:
  • M-A (x4): M5x14 Screws
  • M-B (x4): M6x14 Screws
  • M-C (x4): M6x30 Screws
  • M-D (x4): M8x30 Screws
  • M-E (x4): M8x50 Screws
  • M-F (x4): Spacers
  • M-G (x8): Washers
  • M-H (x8): Washers
• For Wall Mounting:
  • W-A (x6): ST8x90 Lag Screws
  • W-B (x6): Ø12x60 Washers
  • W-C (x6): Wall Anchors (for concrete/brick)
• Main Mount Components:
  • A (x1): Spirit Level
  • B (x1): Drill Bit (Ø 6mm / 1/4")
  • C (x2): Wall Plate Arms
  • D (x2): TV Brackets
  • E (x2): TV Bracket Arms
  • F (x7): M6x15 Screws
  • G (x7): M8x50 Screws
  • H (x1): Wall Plate
  • I (x1): Safety Strap

Step 1: Mount the Wall Plate

1a. Locate wall studs or use appropriate wall anchors (W-C) for your wall type (e.g., drywall, concrete, brick). Mark the desired mounting position on the wall.

1b. Use the spirit level (A) to ensure the wall plate (H) is level. Mark the drill hole locations through the wall plate.

1c. Drill pilot holes using the provided drill bit (B) (Ø 6mm / 1/4"). If using anchors, insert them now.

1d. Securely attach the wall plate (H) to the wall using lag screws (W-A) and washers (W-B). Ensure the mount is firmly attached.

Step 2: Attach Arms to Wall Plate

Attach the wall plate arms (C) to the wall plate (H). Secure them using screws (G) and washers.

Step 3: Attach TV Brackets to Arms

Attach the TV brackets (D) to the TV bracket arms (E). Secure them using screws (F).

Step 4: Mount TV to Wall Plate Assembly

Ensure the TV brackets (D) are securely attached to the back of your TV using the appropriate screws and spacers (M-A to M-H) as detailed in Step 7 (Page 1) and the parts list.

Carefully lift the TV with the attached TV brackets and hook them onto the wall plate arms (C) mounted on the wall. Ensure the TV is securely seated.

Use the provided safety strap (I) if applicable, following its specific instructions.

Step 5: Adjust TV Position

Adjust the TV's tilt and swivel as desired. Tighten the adjustment screws to lock the TV in place. Ensure all connections are secure.

Step 6: Final Checks and Cable Management

Perform a final check to ensure all screws and bolts are tightened securely. Route your cables neatly along the mount for a clean installation.

Step 7: Attaching Brackets to TV (Referenced from Page 1)

Select the appropriate screws (M-A through M-E) and spacers (M-F) based on your TV's VESA mounting pattern and thickness. Ensure screws are not too long or too short to avoid damaging the TV or not securing the bracket properly.

Attach the TV brackets (D) to the back of your TV using the selected hardware (M-A to M-H).