Solight 1MK22 TV Wall Mount Installation Manual

Step 1: Install the TV plate.

Attach the TV plate to the back of your television using appropriate screws.

[Diagram: Shows a plate being attached to the back of a TV.]

Step 2: Prepare the Wall

a. Use the wall plate as a template to mark three hole positions on the wall.

b. Drill holes in the wall with a diameter of 8mm and a depth of 60mm.

[Diagram: Shows a wall plate used as a template to mark holes on a wall, followed by drilling.]

Step 3: Secure the Wall Plate

a. Wedge three plastic anchors into the drilled holes.

b. Screw the self-tap screws into the top two plastic anchors. Do not tighten fully; leave approximately 3mm gap from the wall.

[Diagram: Shows plastic anchors being inserted into wall holes, then screws being partially inserted into the top anchors, leaving a gap.]

Step 4: Install the adapter arms.

Attach the adapter arms to the TV plate that is now on the back of the TV.

[Diagram: Shows adapter arms being attached to the TV plate.]

Step 5: Mount the TV

Carefully hang the TV with attached adapter arms onto the wall plate. Use suitable screws selected from the parts bag to secure the TV to the wall plate.

[Diagram: Shows a TV being attached to the wall mount plate using screws.]

Step 6: Secure the Wall Plate

Hang the wall plate onto the partially inserted self-tap screws. Move the wall plate down to align with the lower hole. Insert the second screw and tighten both screws firmly to secure the wall plate to the wall.

[Diagram: Shows the wall plate being hung on the screws, then moved down and secured with additional screws.]

Step 7: Install Cover and Adjust Angle

Install the plastic cover onto the wall plate. Loosen the adjustment knob to tilt the monitor/TV up or down by up to 20 degrees. Once the desired angle is set, screw the knob firmly to lock it in place.

[Diagram: Shows a plastic cover being installed, and a knob being adjusted to tilt the TV up/down by 20 degrees.]