Instructions for SOLIGHT models including: WM59-WW LED COB Strip, WM59-WW, LED COB Strip, COB Strip, Strip
Solight LED COB pásek, sada s adaptérem, vypínač, 5m, 8W/m, 800lm/m, teplá bílá | SOLIGHT
www.solight.cz - /documents/
EN WM59-WW, WM59-NW, WM59-CW LED COB strip Dear customer, thank you for purchasing our product. Please read the following instructions carefully and follow them to serve you safely and to your full satisfaction. This will prevent misuse or damage. Avoid unprofessional handling of this appliance and always observe the electrical appliance usage guidelines. Keep the instruction manual carefully. TECHNICAL PARAMETERS Product code WM59-WW Power input 8W/m Luminous flux 800lm/m WM59-NW 8W/m 800lm/m WM59-CW 8W/m 800lm/m Light temperature 3000K 4000K 6000K IP coverage IP20 IP20 IP20 LED lifetime 50 000 h 50 000 h 50 000 h Tape length 5m 5m 5m INSTALLATION 1. Clean the surface which you are going to stick the LED strip. 2. Adjust the length of the tape as needed. The remaining parts can be reused. Connectors must be purchased for reconnection. 3. The LED strip is equipped with adhesive tape on the bottom. Peel off the covering layer and glue the strip. 4. Finally, plug the power adapter into a power outlet. NOTICE - For maximum durability and performance, install the tapes on an aluminum substrate (in aluminum profiles) to prevent overheating. - The strip is equipped with a power adapter with a switch: AC 230V / DC 12V, 2000mA. - As the length of the LED strip increases, the luminous flux (lm) and power consumption (W) per 1m decreases. With a 5m strip length, the values per 1m decrease by about 25% compared to the values shown. - The strip can be shortened as required (the remaining parts can be further used). - Avoid placing the luminaire near objects that are a source of heat or moisture. - Do not look directly at a lit luminaire for long periods of time as this may cause discomfort or damage to your eyes. - Do not expose the luminaire to the outdoors, direct rain or immerse it in water. The luminaire is intended for indoor use. - Periodically wipe the luminaire with a dry or damp cloth only when the luminaire is unplugged. The light source of this luminaire is non-replaceable, at the end of its service life the entire luminaire must be replaced and disposed of in a designated place. This product contains a light source that for design reasons cannot be removed for verification and therefore the entire product is considered a light source. The power cord cannot be replaced if damaged, the unit must no longer be used. Solight Holding, s.r.o., Na Brn 1972, Hradec Králové 500 06, Czech Republic. 3Adobe PDF Library 23.6.156