User Guide for ErgoFocus models including: Z213 Monitor Riser, Z213, Monitor Riser, Riser
ErgoFocus Triple Monitor Stand Riser, Extra Long Monitor Riser for 1~2~3 Monitors, Dual Monitor Stand with Length and Angle Adjustable, 3 Shelf Monitor Stand for Desk : Electronics
PRODUCT DISPLAY Monitor Riser User Guide V1.0 Swivel Swivel CAUTION AND MAINTENANCE · Never allow children to climb, stand or play on the monitor riser. · This product is intended for indoor use only. Otherwise, it may lead to product failure. · Do not exceed weight capacity. We cannot be liable for damage or injury caused by incorrect assembly or inappropriate use. · This product contains small items that could be a choking hazard if swallowed. NOT FOR CHILDREN UNDER 3 YEARS OLD. ADULT SUPERVISION IS REQUIRED. 04 01 PACKAGE CONTENTS A (x1) Left Middle Desktop B (x1) Right Middle Desktop C(x2) Short Leg D (x1) Bottom Support Board E(x2) Side Desktop F(x2) Long Leg G (x10) Cam Lock Bolt H (x10) Eccentric Nut I (x2) Short Dowel Pin J(x1) Long Dowel Pin K(x1) Fixture L (x6) Short Bolt M (x1) Allen Key ASSEMBLY STEPS STEP 1 1-1 Connect the Left Middle Desktop (A) and the Right Middle Desktop (B) with the Long Dowel Pin (J). J A B 1-2 Attach the Fixture (K) to the Middle Desktop. 1-3 Insert the Short Bolt (L) to the Middle Desktop, tighten the Short Bolt (L) with the Allen Key (M). L M K A B A B 02 STEP 2 2-1 Insert the Cam Lock Bolt (G) to the Middle Desktop, tighten the Cam Lock Bolt (G) with the screwdriver. TOOL G A B G Screw bolts to the end. NOT INCLUDED 2-2 Attach the Short Leg (C) and the Bottom Support Board (D) to the Middle Desktop. 2-3 Insert the Eccentric Nut (H) into the Short Leg (C) and the Bottom Support Board (D), tighten the Eccentric Nut (H) with the screwdriver. H C H D C Nut's arrow must toward the hole, then turn clockwise to tighten. STEP 3 3-1 Insert the Cam Lock Bolt (G) to the Side Desktop (E), tighten the Cam Lock Bolt (G) with the screwdriver. TOOL G G NOT INCLUDED E ×2 Screw bolts to the end. 3-2 Attach the Long Leg (F) to the Side Desktop (E). 3-3 Insert the Eccentric Nut (H) into the Long Leg(F), tighten the Eccentric Nut (H) with the screwdriver. F ×2 E H H ×2 Nut's arrow must toward the hole, then turn clockwise to tighten. STEP 4 4-1 Insert the Short Dowel Pin (I) to the assembled Middle Desktop. 4-2 Attach the assembled Side Desktop (E) to the Middle Desktop. E I E B A TOOL NOT INCLUDED 03Adobe PDF library 15.00 Adobe Illustrator(R) 24.0