User Manual for SECOMP models including: 12991105, USB 3.2 Gen 1 to Gigabit Ethernet Converter, 12991105 USB 3.2 Gen 1 to Gigabit Ethernet Converter, Gigabit Ethernet Converter, Ethernet Converter, Converter
For optimum performance and safety, please read these instructions carefully before connecting, operating or adjusting this product. Please keep this manual for ...
7 days ago — 1.0 INTRODUCTION. The USB 3.0 to Gigabit Ethernet Adapter is a high performance and low-cost solution. It enables Gigabit Ethernet network connection ...
USB 3.2 Gen 1 to Gigabit Ethernet Converter 12.99.1105 User Manual DEAR CUSTOMER Thank you for purchasing this product. For optimum performance and safety, please read these instructions carefully before connecting, operating or adjusting this product. Please keep this manual for future reference. 1.0 INTRODUCTION The USB 3.0 to Gigabit Ethernet Adapter is a high performance and low-cost solution. It enables Gigabit Ethernet network connection capability for desktops, ultra book with standard USB port. It resolves the trouble of the computer without Ethernet port that you can also connect computer to Ethernet through USB 3.0 port easily. 2.0 FEATURES Single chip USB 3.0 to 10/100/1000M Gigabit Ethernet controller with Energy Efficient Ethernet (EEE). Features as below: Integrates on-chip USB 3.0 PHY and controller compliant to USB Spec 3.0, 2.0 and 1.1 Supports all USB 3.0 power saving modes (U0, U1, U2, and U3) Supports USB Super/High/Full Speed modes with Bus-power or Self-power device auto-detect capability Supports IEEE 802.3az (Energy Efficient Ethernet) Supports parallel detection and automatic polarity correction Supports IPv4/IPv6 packet Checksum Offload Engine (COE) to reduce CPU loading USB3.0 to Gigabit Ethernet Adapter Supports TCP Large Send Offload V1 Supports full duplex operation with IEEE 802.3x flow control and half duplex operation with back-pressure flow control Supports IEEE 802.1P Layer 2 Priority Encoding and Decoding Supports Jumbo frame PHY loop-back diagnostic capability Support Wake-on-LAN Function Supports suspend mode and remote wakeup via link-change, Magic Packet, Microsoft Wakeup Frame and external wakeup pin Support windows 8, windows 7, windows vista, Apple 10.6 and Apple 10.8 2.0 SPECIFICATIONS Connectors USB 3.0 Ethernet Power Requirement External Power Supply Power consumption (Max) USB Male RJ45 Female No 0.5W Note: Specifications are subject to change without notice. 3.0 PACKAGE CONTENTS Before attempting to use this unit, please check the packing and make sure the following items are contained in the shipping carton: Main unit x1 User's Manual x1 CD driver x1 4.0 PANEL DESCRIPTIONS 1. USB3.0 Connect the port to the PC Host. 2. RJ45 Connect the port to the Ethernet Router or Networking by a Networking cable. USB3.0 to Gigabit Ethernet Adapter 5.0 CONNECTION AND OPERATION 1) Driver installation Drive specific installation process please refer to the CD Manual. 2) Connection Connect computer to USB 3.0 port of this product Connect RJ45 of this product to Ethernet Router by Ethernet cable automatically or manually set IP address of computer. 5.1 CONNECTION DIAGRAMMicrosoft: Print To PDF