Kiss Pool 1177_68596

Product Overview

The Kiss Pool 1177_68596 is a rechargeable electric vacuum cleaner designed for underwater use in pools and spas. It offers efficient cleaning of debris and is easy to assemble and maintain.

Specifications

Battery: 11.1V DC, 2.0Ah

Charging Voltage: 12.6V DC, 1000mAh

Motor Voltage: 12V DC

Maximum Operating Depth: 3 meters (10ft)

Operating Water Temperature: 4 °C (39.2 °F) - 35 °C (95 °F)

Parts List

Note: Dimensions may vary slightly.

Safety Warnings and Instructions

Read and follow all instructions. Failure to do so could result in severe or fatal injury.

• This cleaner is not intended for use by persons with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless supervised.
• This is not a toy. Children must be supervised and kept away from the cleaner and its accessories. Never allow children to operate this product.
• Ensure the cleaner is fully immersed in water before operation. DO NOT operate it outside of water, as this can damage the shaft seal/motor and void the warranty.
• Maximum operating depth: 3 meters (10ft).
• Operating water temperature: 4 °C (39.2 °F) - 35 °C (95 °F).
• DO NOT use if any damage is found. Replace damaged parts with certified parts only.
• Detach the cleaner from the charger and ensure it is powered off before use.
• DO NOT operate when people or pets are in the water.
• Risk of Suction Entrapment Hazard: Avoid hair, body, or loose clothing contacting the suction hole.
• Never insert body parts, clothing, or other objects into openings or moving parts.
• DO NOT use to pick up toxic substances, flammable or combustible liquids (e.g., gasoline), or operate in the presence of explosive or flammable fumes.
• Never attempt to disassemble the cleaner, impeller, or motor yourself.
• Use original accessories only.
• DO NOT use immediately after pool shocking; allow pool to circulate for 24-48 hours.
• DO NOT use with another cleaner simultaneously.
• DO NOT leave the cleaner in water when not in use or when the battery is low to prevent water leakage.
• Ensure the transparent suction part is properly installed before powering on.

Charger Safety:

• For indoor use only. Do not expose to rain, humidity, liquid, or heat.
• Keep out of reach of children.
• Never use if damaged.
• DO NOT handle with wet hands.
• DO NOT handle the cleaner or charger while charging with wet hands and without shoes.
• Disconnect from power when not in use.
• If the supply cord is damaged, it must be replaced by the manufacturer or a qualified person.
• Ensure the cleaner and charger are totally dry before charging.

Battery Disposal:

• The battery is a lithium battery and must be disposed of properly according to local regulations.
• Never attempt to disassemble a lithium battery.
• Remove personal items (rings, bracelets, watches) before handling the battery.
• Batteries can produce a short circuit current high enough to cause severe burns.
• Wear eye protection, gloves, and protective clothing when removing the battery.
• Avoid touching wires together or allowing them to contact metal items.
• Never smoke or allow sparks/flames near the cleaner; batteries can generate ignitable gases.
• DO NOT expose to fire or intense heat, as this may result in an explosion.
• If a battery leaks acid, avoid contact, place in a plastic bag, wash affected skin/clothing with soap and water, and flush eyes with cool water for at least 15 minutes, seeking medical attention.

Note for Children's Product: Not suitable for children under 3 years. Contains small parts (suffocation hazard) and ropes (strangulation hazard). [age restriction 0-3] [suffocation hazard] [strangulation hazard]

Getting Started

Battery Charging

Diagram shows charger connected to wall socket (green light) and then to the cleaner (red light). After 3 hours, the light turns green, indicating a full charge.

1. Plug one end of the charger into the socket; the charger light turns green.
2. Plug the other end of the charger into the cleaner (P1111); the charger light turns red, indicating charging is in progress.
3. After approximately 3 hours, the charger light turns green, and the cleaner is fully charged.

WARNING: Charging must be done indoors in a well-ventilated area, away from sunlight, children, heat, and ignition sources. Use only the original charger. Ensure cleaner and charger are clean and dry before charging.

Note: Charge for 3 hours before first use. A full charge provides 45-60 minutes of operation.

Setup for Operation

Diagram shows assembly sequence: 1 (Suction head), 2 (Transparent suction head part), 3 (Cleaner body), 7 (Handle), 8/9 (Basket/Filter bag).

The arrow on the transparent suction head part must be aligned with the arrow on the cleaner body. Then, insert the transparent garbage can to the bottom of the transparent body. Rotate 90 degrees to open or close.

Assembly Instructions

Handle Assembly

Insert the handle into the rear compartment connector until the side pin clicks into the Handle Locking Hole. Adjust position as needed for comfortable cleaning. To release, press the side pin and pull the handle back.

Diagram shows inserting the handle and pressing a side pin to release.

Telescopic Pole Assembly

Insert one end of the telescopic pole connector into the cleaner until the side pin clicks into the Hand Locking Hole. Align side holes of the pole with the pins of the connector. To release, press both side clips simultaneously and pull the pole back.

Diagram shows inserting the pole connector and releasing it.

Suction Head Assembly

Insert the suction head directly and tightly into the suction hole of the cleaner. For optimal suction:

• Use the suction head with brushes attached for small pebbles and leaves (Picture A).
• Remove the suction head for larger debris like stones (Picture B).

Brushes on the suction head can be removed by pulling them out. It is recommended to keep brushes on for vinyl, liner, and fiberglass pools to prevent damage.

Diagrams A and B show different suction head configurations.

Cleaning and Maintenance

Cleaning the Cleaner After Use

Diagrams show steps A, B, C, D for cleaning the cleaner.

1. Remove the transparent body (rotate OPEN 90 degrees), empty debris, and clean it.
2. Remove the rear filter bag and basket, empty debris, and clean the filter bag.
3. Check the impeller for debris and clean if necessary.

Filter Bag Cleaning Steps:

1. Pull out the basket and filter bag from the rear of the cleaner.
2. Detach the filter bag from the filter basket.
3. Clean the filter bag and filter basket.

Diagrams show filter bag removal and cleaning.

Operation

WARNING: Do not use if damaged. Liquid pollution may occur due to lubricant leakage. Do not operate when people or pets are in the water. Ensure the cleaner is fully immersed before operating. Never use outside of water, as it will void the warranty.

Maximum water temperature: 4°C (39.2°F) - 35°C (95°F).

DO NOT use without an intact filter sock and sleeve; this will void your warranty.

Risk of Suction Entrapment Hazard: Avoid contact with the suction hole.

Never insert body parts, clothing, or objects into openings or moving parts.

DO NOT use for toxic, flammable, or combustible liquids, or in explosive/flammable fumes.

DO NOT use immediately after pool shocking; allow 24-48 hours for circulation.

DO NOT use with another appliance simultaneously.

DO NOT leave in water with low battery, as leaks may occur.

Ensure the transparent suction part is installed correctly before powering on.

Battery Replacement

How to remove the battery:

1. Press the small clip to release the rear body cover.
2. Rotate the rear body counterclockwise and remove the large button part.
3. Locate and remove the triangular battery.
4. Install the new original battery correctly and rotate tightly.
5. Rotate the rear cover onto the body, ensuring the battery is installed correctly.
6. Secure the small buckle to the cover position; it should click.
7. The cleaner is now ready for use.

Diagrams A, B, C, D show battery removal and installation steps.

WARNING: Never attempt to disassemble a lithium battery. Remove personal items. Batteries can cause severe burns due to short circuits. Wear protective gear. Avoid sparks or flames. Do not expose to fire or intense heat.

CAUTION: If a battery leaks acid, avoid contact, place in a plastic bag, wash skin/clothing with soap and water, flush eyes with cool water for 15 minutes, and seek medical attention.

Troubleshooting

How to determine if the battery is damaged or the impeller is jammed:

1. If the impeller suddenly stops: Turn off, connect to charger. If Green LED is on, battery is damaged. If Red LED is on, check if impeller rotates. If not, it's jammed.
2. After charging, Green LED is on, but impeller doesn't work: Turn off. Connect charger, press button to check for impeller sound. A "Kaka" sound indicates jamming. If no sound, turn off, disconnect charger, turn on again. If impeller still doesn't work, battery is destroyed.
3. Use a voltmeter: Charge battery for 10+ minutes. Remove battery, measure voltage. If 0, battery is dysfunctional. If not 0, impeller is jammed.
4. Directly rotate the impeller until it moves freely. If it doesn't rotate after charging, the battery is destroyed.

Company Information

Responsible for commercialization: GECODIS SA

32, rue de paradis, 75010, Paris, France

Commercial Service: Habitatetjardin.com

32, rue de paradis, 75010, Paris, France

Assistance: +33 (0) 1 47 70 33 64

After-Sales Service: GECODIS SA

32, rue de paradis, 75010, Paris, France

Website: http://sav.habitatetjardin.com