Components
- x1 70.9" Power Cord
- x1 Lifting Ring
Easy Installation
Required Tools: Ladder, Drill, Safety Cables
Turn off power at circuit breaker
Turn off power at the circuit breaker before installing. [Power Off Indicator]
Drill pilot hole in ceiling and install mount
Drill pilot hole in ceiling and install chain or ceiling hook (not included) for adequate support.
Attach lifting ring
Attach lifting ring by turning clockwise into UFO fixture. Tighten firmly into place.
Hang fixture
Use lifting ring to hang fixture onto ceiling hook.
Secure with safety cables
Secure light with safety cables (not included) to prevent it from falling.
Connect power
Plug UFO light into nearby power outlet.
Turn on power and test
Turn on circuit breaker and test light. [Power On Indicator]
Specifications
| Specification | Value |
|---|---|
| Voltage | 120 VAC |
| Wattage | 150W |
| Moisture Rating | Wet |
| Housing Material | PC + Aluminum |
| Weight | 3.5 lbs |
| Warranty | 7 Years |
Warning
To reduce the risk of fire, electric shock, or physical injury:
- This product should be installed by a person familiar with the construction and operation of the product and the hazards involved.
- Check for shipping damage prior to install. If the product is damaged, do not use it.
- Turn off the switch and circuit breaker before installing. Do not use an electric generator to test the fixture.
- Proper grounding is required to ensure safety.
- The entire length of the power cord should remain visible and should not be concealed.
- Please use listed waterproof strain relief bushing when connecting the supply cord to the outlet box.
- If you experience smoke or fire in the wires or lamps during or after installation, turn off the power immediately and notify relevant personnel.
- Clean the fixture regularly to ensure proper operation. Do not clean with harsh solvents.
- Use safety precautions and abide by regional and local laws or regulations.
- Safety eyeglasses and gloves are recommended.
FCC Notes
- This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
- Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
