Smart Home | Consciot
Instructions for Spring Sunshine Technology models including: LM459, 2AW95LM459, LM459 Wireless Charger Table Light, Wireless Charger Table Light, Charger Table Light, Table Light, Light
SPRING SUNSHINE TECHNOLOGY CO., LIMITED LM459 Wireless Charger Table Light 2AW95LM459 2AW95LM459 lm459
File Info : application/pdf, 2 Pages, 624.91KB
DocumentDocumentTechnical Information Model: LM459 Finish: White Input power: 9V 2A(Adapter included) Light Power: 4.5W Power source: 40*2835 LED Module Color temperature:3000K / 4000K / 6500K Luminous Flux: 400lm CRI>90 Wireless charging power: Max 10W USB output: 5V 1A(Max 5W) Materials: ABS+Aluminum Packing list: table light*1+User manual*1+ USB cable*1+9V 2A adapter*1 Instructions for use USB ports Micro USB ports Switch buon Indicator light Phone wireless charging area 1. Micro USB ports for connecng the table light: when use this table light please use matching adapter DC 5V/2A or 9V/2A. 2. USB ports for phone wire charging, USB output DC 5V/1A, max power 5W. 3. Dimmable control: tap and hold on the switch buon, then it can be dimmable, geng brighter or geng darker. 4. CCT control: Tap the switch buon, then it can be CCT control, 3000K/4000K/6500K/Off. 5. Wireless charging indicator light status: The light will flash three mes when power on, and it will not be on when standby. When charging, the indicator light will be red. When the mobile phone is fully charged, the indicator light will be green. When there are metal foreign maers or over temperature, the red light will flash. When the power supply is insufficient, the green light will flash. 6. Try to keep the mobile phone in the middle of charging area, and it's compable with all wireless charging mobile phone which have QI protocols. Noce: For smooth wireless/USB charging, please ensure the power input reaches 9V/2A(using our own adapter). The supply from PC, power bank, or other adapter might be below the level, leading to slow charging or not charging. 5V/2A---Enable table lighng and wireless charging(slow). 9V/2A---Enable table lighng, wireless charging and USB charging at the same me. After-Service 24-month warranty is provided for this device from the date of purchased. For any quesons/ assistance/support, please call the customer service or contact us by E-mail. SPRING SUNSHINE TECHNOLOGY CO.,LIMITED Adr:Room 2401-2404, 24/F., Fu Fai Commercial Centre, 27 Hillier Street, Sheung Wan,HongKong Phone: 1-855-955-7007(24x7) Website: www.consciot.com E-mail: support@consciot.com Made in China 20cm FCC WARNING This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. To maintain compliance with FCC's RF Exposure guidelines, This equipment should be installed and operated with minimum 20cm distance between the radiator and your body: Use only the supplied antenna.