LiteBee Kids Drones | Professional Programming Drone for Kids| Coding for KidsEducational drone Coding for Beginners | Support-litebee wing
User Manual for LiteBee models including: Y18 Obstacle Avoiding Unit, Y18, Obstacle Avoiding Unit
包装清单、参数 02 Obstacle avoiding unit * 1 Short bolt * 1 Connecting cable * 1 Model: Y17-AI Size: 40*40*8mm Working voltage/current: 5V/@80mA
LiteBee Wing Kit de détection d'obstacles, 119.00 Fr.
File Info : application/pdf, 14 Pages, 2.58MB
DocumentDocumentObstacle Avoiding Unit Product Manual CONTENTS 1 Product introduction 01 Brief introduction 4 Installation 06 Installing steps 2 About the product 02 Packing list 02 Specification 5 Programming 08 Reference case 3 Firmware 03 Firmware version 05 Firmware updating Introduction The obstacle avoiding module is one of extensions for LiteBee Wing drone, it can sense the obstacle of 5 directions(forward/backward/left/right/below). Combined with LiteBeeGo programming, the module enables the drone to avoid the obstacle and the following crash. This module makes the knowledge application more interesting, allowing students to learn through play, and inspire their curiosity for exploring drones and AI. 01 Packing list Obstacle avoiding unit * 1 Connecting cable * 1 Short bolt * 1 Specification Model: Y17-AI Size: 40*40*8mm Working voltage/current: 5V/@80mA Size of QR code: 24*30cm Max load: 500g Actual load: 0-8g 02 PREPARATION Firmware version Note: To apply this module, the version of firmware for aircrafts or controllers should be V1.1.0 (and up), the version of software should be LiteBee Go V0.2.1(and up). How to check the version Link the aircraft with the controller Connect the controller with the host computer by USB micro wire Switch the controller into programming mode Click the exclamation mark to make sure the controller connected Choose "LiteBee Wing" mode Click the "Add Extension" Check the information on the right bottom Start LiteBee Go FV shows the version of the aircraft RV shows the version of the controller 03 pic 1 pic 3 pic 2 pic 4 04 How to update the firmware version To download the corresponding document for firmware upgrading on LiteBee official web Or, you can find relevant video for firmware upgrading on YouTube channel - LiteBee, search "Guide for firmware upgrade" Official Website:https://www.litebee.com/product/liteBeeWing/download 05 pic 5 INSTALLATION 1 *4 2 *1 *1 Insert four short bolt into the bottom of the drone Insert the connecting cable into the obstacle avoiding module 06 3 4 Install the module in the bottom of the drone by short bolt Pay attention to side of the module 07 Link the connecting cable to drone's 4-pin interface EXTENSION PROGRAMMING Step 1: Connect the aircraft with the host computer Turn the drone on and link to the controller Connect the controller with the host computer by connecting cable Step 2: Switch to obstacle avoiding mode Start LiteBee Go Click "Add extension" Choose "Obstacle abvoiding mode" PS: Click the excalmatory mark if the it isn't connected. 08 Reference case Mission: Let the drone take off and then fly forward, landing if meet any obstacle. Programming case Mind map Start Calibrate Take off and fly forward If the distance between aircraft and obstacle less than 30 cm Land 09 Manufacturer: Shenzhen Makerfire Technology Co., Ltd. Website: www.litebee.com Tel: 44-830-2598 Email: sales@litebee.com Address: 25th Floor, A7 Building, Creative City, Liuxian Ave, Xili Street, Nanshan District, Shenzhen, China.