Home - Motionics LLC
User Guide for motionics models including: VibeSense Vibration Analyzer, VibeSense, Vibration Analyzer, Analyzer
Download – Motionics LLC
File Info : application/pdf, 1 Pages, 141.77KB
DocumentDocumentVibeSense Vibration Analyzer User Guide ! Important Notes Turn off the device after use. It will NOT turn off automatically. Do NOT open the device. Opening causes permanent damage and voids the warranty. This device is pre-calibrated. You will need a 1g 159Hz vibration shaker if you want to calibrate it again. Description 1 Mounting Hole connect to magnetic base or fixture with ¼-28 set screw 2 Magnetic Switch Sensing Region move magnetic switch key close to turn the device on/off 3 Status LED Device is on (flashing)/device is connected (solid) Device is in charge Device is fully charged 4 Tachometer Connector connect to laser tachometer sensor (available in rotor balancing kit) 5 Wireless Charging Coil flip the device and place on wireless charging pad to recharge battery 5 4 3 2 1 Included in the box VibeSense Wireless Accelerometer Magnetic On/Off Switch Key ¼-28 Accelerometer Mounting Set Screw Qi Wireless Charging Pad USB Charging Cable USB Power Adapter User Guide Compatible Software iOS: VibraTestPro iOS app can be directly downloaded from the App Store Quick Start Attach VibeSense wireless accelerometer to the testing machine/fixture directly with 1/4-28 set screw or via magnetic base. Move magnetic switch key close to the sensing region on VibeSense accelerometer to turn on the device. Launch VibraTestPro app. Go to the Setting page in the app and make sure Wireless is selected for Sensor. On the main page, tap the Sensor button on the bottom right corner to bring up the sensor pairing/status page. Move the iPad close to the accelerometer; it will be detected and connected. Tap the Vibration Meter button to launch ISO-10816 based vibration meter and tap Update to get overall RMS reading. Tap the Spectrum button to launch the signal viewer for vibration waveform and FFT spectrum. Tap the Update button in the middle of bottom tool bar to receive raw signal. Tap Record button to launch signal recording page to record raw vibration signal. To disconnect the device, go to the sensor pairing/status page again and tap the Disconnect button. To turn off the device, move the magnetic switch key close to the sensing region on the VibeSense accelerometer. To recharge the device, flip and place it on the wireless charging pad. Motionics, LLC www.motionics.com 8500 Shoal Creek Blvd Building 4 Suite 209, Austin, TX, 78757 © 2020 Motionics, LLC. All rights reserved. info@motionics.com Made in the U.S.A