Instruction Manual for HALCYON models including: EX160 Exterior One Way LED Column Spot Light, EX160, Exterior One Way LED Column Spot Light, One Way LED Column Spot Light, LED Column Spot Light, Column Spot Light, Spot Light, Light
10 avr. 2023 — If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer or his service agent or a.
FIG-1 EX160 This luminaire must be installed by a qualified Registered Electrician to prevent damage to the luminaire and maintain electrical safety. If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard. The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced. Base plate,cable entry gland and screw heads must be covered in silicone sealant. Failure to do so may cause luminaire failure from water ingress. All exterior luminaires (with the exception of copper) require periodic cleaning to protect the surface and/or coating from corrosion and ensure tidy appearance for the lifespan of the product. Wash with care using a soft brush and warm soapy water using a neutral detergent. Coastal areas require extra attention, especially fittings which are under eaves/soffits and do not have any exposure to rain. Do not use a water blaster or high pressure hose, do not submerge fittings for extended periods of time. 316 stainless steel fittings will still develop surface rust or "tea staining" if left uncared for. 1 OFF ON 2 FIG-3 wrench,gasket FIG-4 H05RN-F 3×1.0mm² for cable/pipe mm: 5-10 2 1 29MM FIG-2-A Concrete 31MM 1 FIG-2-B When the light face up, arrow goes up; when the light face down, arrow goes down Wood board Please make sure the thickness of the wood board no less than 5mm Freely choose tool to fix the backstand. 56MM Note: Please keep 2 the cable outlet in 3 the same vertical direction with the inlet to luminaries Note: In order to reach the required IP, the input cable for the luminaries must be H05RN-F 3×1.0mm², and threading through before stripping. FIG-5 1 2 gasket The light face up Pri:220-240V 1 1 N L 2 2 N L 0.5-2.5mm² with release facility blue brown green/yellow The light face down 1 2 1 OFF ON 2 ver:1.2