COLAMY INSTRUCTION MANUAL
Model No.: B248
WARNING
Please read the instructions carefully and follow the assembly steps.
To ensure proper assembly, please follow all steps and use all parts provided. Not following this warning may result in serious injury to you or others.
To prevent misalignments, keep the screws loose and do not tighten them until they are all in their correct positions.
Avoid overtightening or forcing the screws, as this could cause them to break, strip, or damage the threads of the holes.
Using the wrong size of screws for a particular part could cause damage to the screw or the part.
Please lubricate all moving parts regularly and tighten all bolts and screws every 6 months, or as needed.
SAFETY INFORMATION
WEIGHT CAPACITY FOR SEATING: 300LBS
- ✔️ Sit in the center of the chair with your back against the backrest
- ❌ Do not sit at the front edge of the chair
- ❌ Do not stand on the chair
- ❌ Do not use the chair with more than one person
- ❌ Do not push the chair around when a person is sitting in it
- ❌ Do not push down on the backrest when a person is reclined
- ❌ Do not place all your weight on the backrest only
ASSEMBLY PARTS AND TOOL
BEFORE YOU GET STARTED, A FEW POINTERS:
Please open the Seat Cushion bottom and take out all accessories before installation.
Please use the included wrench ? instead of an ELECTRIC HAND DRILL in case of damage to the chair leg.
Parts List:
- Seat Back *1
- Seat Base *1
- Legs *4
- Bolt M8*50 mm *3
- Flat Washer Ø8/Ø30 mm *3
- Flat Washer Ø10/Ø48 mm *4
- Wrench *1
- Felt Pad Ø25 mm *4
- Back Pillow ☁️ *1
PLEASE MAKE SURE ALL THE PARTS ARE INCLUDED.
MISSING PARTS? support@colamyhome.com
ASSEMBLY INSTRUCTIONS
Step 1
Unzip the fabric cover underneath the Seat Base(2) Bottom and take out all accessories.
Step 2
Connect 4 legs to the Seat Bottom. Tear off the 4 Felt Pad(8) and glue them to the bottom of the chair legs. On a clean surface, gently turn the Seat Bottom on its side.
Step 3
Insert 4 Legs(3) with 4 Flat washer Ø10/Ø48mm(6) into the holes and tighten them.
Step 4
Connect Back Cushion(1) with Seat Base(2). Put the Seat Base upright on the ground, align the Back Cushion(1) with the Seat Base(2), and gently press the Back Cushion(1) to make it secure. Then, lay them on their side and align the 3 screw holes.
Step 5
Tighten the 3 screw holes by using 3 Bolt M8*50mm(4) and 3 Flat Washer Ø8/Ø30mm(5), using the Wrench(7). Adjust the balance of the chair and close the cover.
Put the Seat Bottom upright on the ground and put the pillow on. Now, your chair is installed successfully.
LIMITED WARRANTY
COLAMY promises to repair or replace any COLAMY chair that is found to be defective in material or workmanship within one year from the date of original purchase so long as you, the original purchaser, still owns it. This is your sole and exclusive remedy. This warranty is subject to the provisions below.
EXCLUSIONS
This warranty does not apply and no other warranty applies to:
- Normal wear and tear, which are to be expected over the course of ownership.
- Misuse, abuse, or excessive use of the product.
- Modifications or attachments to the product that are not approved by COLAMY.
- Products that were not installed, used, or maintained in accordance with product instructions and warnings.
- Products used for rental purposes or unauthorized retail activities.
Seating Usage: Normal use for seating is identified as the equivalent of a single shift, forty- (40) hour workweek. To the extent that a seating product is used in a manner exceeding this, the applicable warranty period will be reduced in a pro-rata manner.
RETURN POLICY
We adopt a 30-day return policy which means that all products purchased on this website may be returned to us within the timeframe. You need to contact us within 30 days after the product(s) came into your possession and the product(s) must be returned to us without any undue delays.
Returned products must be returned in the same condition as they were sent and they must be sent in their original packaging.
If the product is not faulty, (i.e. if you changed your mind or if you are unhappy with the product for some other reason), the cost of shipping will fall on you. And it is your responsibility that the package arrives safely to us so we recommend that you use a courier service where it is possible to track the shipment.
HOW RETURNS WORK
If the product is faulty when you receive it, please contact us and we will help you out.
We reserve the right to give a partial refund in cases when the product(s) is not in an unused condition, is damaged or has missing parts, not due to our error.
To request a return, please fill out the contact form on our website and attach a copy of your invoice as proof of purchase and the reason for your return in the message.
Then we will provide the return address for the product as soon as possible.
Once the returned product has been received by us and inspections have been completed, a specific disposition will be provided to you.
In addition, if the return is approved, the refund amount will be automatically credited to your original payment method.
TEL: 800-507-2215
WEB: colamyhome.com
E-MAIL: support@colamyhome.com
CAUTION: COLAMY disclaims any liability for damages or injuries which may occur due to failure to properly follow assembly instructions, properly assemble the product, or properly use the product.
For assembly videos, visit: YouTube Assembly Video








