Home - Human Active Technology
Installation Guide for Innovative Design Works models including: PTS-04-UNIV Universal Payment Terminal Stand, PTS-04-UNIV, Universal Payment Terminal Stand, Payment Terminal Stand, Terminal Stand
Installation Instructions | Innovative Design Works
Universal Payment Terminal Stand | Innovative Design Works
File Info : application/pdf, 8 Pages, 1.57MB
DocumentDocumentPTS-04-UNIV Installation Instructions Innovative Ergonomic Solutions 800 524 2744 customerservice@team-ies.com team-ies.com PAGE 1 OF 8 © 2021 Innovative Ergonomic Solutions REV A A T20 L-Key 1x 714997 B T25 L-Key 1x 714899 C 4mm Hex Key 1x 709877 PTS-04-UNIV Installation Instructions PAGE 2 OF 8 1 i IMPORTANT: Determine cable routing prior to installing mount. This will ensure the mount is installed in the correct orientation for your installation. Above Surface Cable Routing Locate the mount cable exit and plan your installation accordingly. Cable Entry Cable Exit Below Surface Cable Routing Cables may pass through the mount (requires grommet hole). Cable Entry Cable Exit For above surface cable routing, route the cable prior to installing the mount. Mounting hardware not included. Use appropriate hardware for your mounting surface. Optional grommet hole for routing cables below mounting surface. PAGE 3 OF 8 2 ROTATION Placement of the two rotation stop screws in the outer ring determine the amount of payment terminal rotation. You can remove the screws from their original location and place them in any of the holes in the outer ring to allow for the amount of desired rotation. i ROTATION STOP CONFIGURATION EXAMPLES OR T20 NO ROTATION There are rotation stop ribs underneath the top portion of the mount that can be placed directly over the rotation stop screw or pin. This positioning will prevent the payment terminal from rotating. Determine the proper rotation stop screw location for your installation. Rotation Stop Ribs Place this area over the rotation stop screw or pin to prevent the mount from rotating. i NO ROTATION CONFIGURATION EXAMPLES Rotation Stop Screw T20 Rotation Stop Screw PAGE 4 OF 8 Rotation Stop Pin Rotation Stop Screw 3 When placing the top of the mount onto the base, ensure the rotation stop ribs fall in between the rotation stops that were set in place in Step 2. Or in a no rotation configuration, the ribs must be placed over top the rotation stop screw or pin. i HOW TO RELEASE MOUNT Locate the release tab inside the mount. Using a screwdriver, or similar tool, pull back on the tab. With the tab pulled back, lift up on the upper portion of the mount to release. PAGE 5 OF 8 Release Tab 4a T25 4b T25 PAGE 6 OF 8 5 4mm i CLAMP POSITIONS Clamps can be attached to the various slots shown below to accommodate a variety of payment terminals. 4mm PAGE 7 OF 8 6 OR i ADJUSTMENT FEATURE To adjust the tilt friction, remove the hex nut covers and tighten or loosen the 13mm hex nut while securing the pivot screw on the inside of the mount with a 14mm wrench. Adjust both sides as needed. 14mm 13mm PAGE 8 OF 8