SINDOX Direct
User Manual for SINDOX models including: OJD-60, OJD60, 2A5R4-OJD-60, 2A5R4OJD60, OJD-60 15W Wireless Charger, OJD-60, 15W Wireless Charger
Foshan Shendu Network Technology Co., Ltd OJD-60 Fabric Wireless Charger 2A5R4-OJD-60 2A5R4OJD60 ojd 60
File Info : application/pdf, 2 Pages, 1.92MB
DocumentDocumentLED Indicators Information 1. Power on: blue light and red light flash once. 2. Standby mode: red light. 3. Charging: blue light. 4. FOD/Charging anomaly: blue light flashing. Email: sindox.service01@outlook.com Website: www.sindoxx.com 15W Wireless Charger User Manual Product Parameter: Model Color Material Quick Charge Input Output Size Conversion rate OJD-60 Gray, Blue Zinc alloy QC3.0 DC 5V/2A,9V/1.67A,12V/1.5A 5W/7.5W/10W/15W(max) 100mm*9mm 73% Note 1.Please do not disassemble the product at will. 2.Please do not use this product in high temperature, damp environment. 3.To charging contact surface on the back of the mobile phone cannot carry metal materials such as iron sheets, finger rings, metal protective shells, etc. Packing List Zinc Alloy Wireless Charger x 1 Type-C USB Cable x 1 User's Manual x 1 Warranty Card x 1 How to use the wireless charger? 1. Connect the Type-C USB cable into the charger port. 2. Plug the USB connector into the QC3.0 power adapter. 3. Connect power adapter to power outlet. 4. Place the wireless charging device in the center of the charging area to start charging. FCC Information This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Radiation Exposure Statement This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. During the operation of device a distance of 15 cm surrounding the device and 20 cm above the top surface of the device must be respected.