Installation Guide for AViANCE models including: HD67509, HD67455, HD67509 4 Light Black with Brushed Nickel Accents, HD67509, 4 Light Black with Brushed Nickel Accents, with Brushed Nickel Accents, Brushed Nickel Accents, Nickel Accents
24 ore fa — However, the installation instructions do apply to this product. HD67509. ◇ WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER. ◇ ATTENTION! COUPER LE ...
ASSEMBLING & INSTALLATION INSTRUCTIONS The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product. FIG.1 Junction Box (Not included) HD67509 Ground Wire WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER. ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR. ASSEMBLING THE FIXTURE (Fig.1) 1. Shut off the power at the circuit breaker box. Remove old fixture and Fixture Ground Wire Mounting plate Mounting screw all hardware from Junction Box. The junction box is not included. 2. Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for A installation. 3. Determine the desired hanging height. Slide the electrical wires through the shade(F)/ thin nut(E)/tubes(D)/(C)/(B) and canopy(A). 4. Raise the center hole of shade(F) to top thread of lamp holder(G), D0.5"*L6'' 1PC D0.5"*L12'' 1PC Column nut B lock it securely with the thin nut(E). Raise the tube(D)/(C)/(B) and canopy(A) to the pipe thread in order, then by turning it clockwise D0.5"*L18'' 1PC C until tight. 5. Thread the two mounting screws into the pre-drilled holes in the D Mounting plate spaced the same distance apart as the holes in the canopy (A). Attach the Mounting plate to the Junction Box with the two Junction Box screws as shown. The side of the Mounting plate marked "GND" must face to out. E F 6. While holding the fixture lamp towards the ceiling, connect the electrical wires as Shown in Fig.2, making sure that all wire nuts are G secured. You may have to wrap the connections with electrical tape. If your outlet has a ground wire (green or bare copper), connect the fixture ground wire to it. Otherwise connect fixture's ground wire directly to the Mounting plate with the green screw provided. After wires are connected, tuck them carefully inside the Junction Box. 7. Raise the canopy (A) on to the Junction box, aligning screws on mounting plate with mounting holes in canopy and lock it securely with the column nuts. 8. Install the light bulbs(Not included) in accordance with the fixture FIG.2 FIXTURE WIRES Black or Smooth FIXTURE WIRES White or Ribbed HOUSE WIRES Black(Hot) HOUSE WIRES White (Neutral) FIXTURE WIRES Bare Copper (Ground) HOUSE WIRES Green or Bare Copper(Ground) specifications. NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE! Thank you for purchasing an AVIANCE product. Need assistance with parts or assembly? Please email customer service Your installation is now complete. Return power to the junction box at:info@aviancelighting.net and test the fixture. ©COPYRIGHT ALL RIGHTS RESERVED. AVIANCE LIGHTING,INC. DOC202503HD67455Acrobat Distiller 9.3.2 (Windows)