Instruction Manual for TOYBOX models including: 62100966F-2, 62100966F-2 Remote Control Stunt Vehicle, Remote Control Stunt Vehicle, Stunt Vehicle, Vehicle

SZ24DTS62100966F BOX R7

User Manual

FOURSTAR GROUP INC 62100966F-2 2AYNN62100966F-2 2AYNN62100966F2 62100966f 2

PDF preview unavailable. Download the PDF instead.

GetApplicationAttachment.html?id=7415986
REMOTE CONTROL STUNT VEHICLE

49MHz

FLIP ACTION
DOUBLE SIDED

LED LIGHTS
360°
ROTATION

49MHz

$5

2x AA
(Remote Control)
4x AAA
(Vehicle)
BATTERIES SOLD SEPERATELY
REMOTE CONTROL STUNT VEHICLE
AGE 5+

BATTERY REPLACEMENT: To replace batteries refer to the following directions:

VEHICLE

VEHICLE
1. Turn the power switch to the OFF position. 2. Use a Phillips screwdriver to loosen and remove the
battery compartment door as shown. 3. Remove old batteries and replace with 4 new 1.5V "AAA" batteries. 4. Replace the battery compartment door and tighten the screw.

1.5V AAA/LR03 1.5V AAA/LR03

1.5V AAA/LR03 1.5V AAA/LR03

REMOTE CONTROL
1. Use a Phillips screwdriver to loosen and remove the battery compartment door as shown.
2. Remove old batteries and replace with 2 new 1.5V "AA" batteries. 3. Replace the battery compartment door and tighten the screw.

USE 4 x 1.5V "AAA" BATTERIES (NOT INCLUDED)

BATTERY CAUTION:

· Alkaline batteries are recommended. · To avoid battery leakage: Do not mix old and new batteries or mix battery

REMOTE CONTROL

types (alkaline, standard or rechargeable batteries) or different brands.

· Do not use rechargeable batteries. Non-rechargeable batteries are

not to be recharged.

· Only batteries of the same or equivalent type as recommended are to be used.

· Install batteries with the correct polarity (+ and -).

· The supply terminals are not to be short-circuited.

· If batteries are loose, bend out the contacts for a tight fit.

1.5V AA/LR6

· Keep loose batteries out of reach of children. · Do not use if battery compartment cover is loose or missing. Keep battery compartment cover secured
with screw.

1.5V AA/LR6

· Exhausted batteries are to be removed from toy. Immediately and safely dispose of any used batteries. · Do not dispose of this product in fire, battery inside this product may explode or leak. · When toy is not in use for an extended period of time, remove batteries to prevent possible leakage and
damage to the unit.

USE 2 x 1.5V "AA" BATTERIES (NOT INCLUDED)

· Check the product periodically for signs of damage to electrical parts; do not play with product until damage has been

properly assessed.

If the unit malfunctions, please remove the batteries for one minute and reinstall again. If the malfunctions persist, please replace with new batteries. MAKE SURE THE BATTERIES ARE PROPERLY INSTALLED AND INSERTED CORRECTLY AND ALWAYS FOLLOW BOTH THE PRODUCT AND BATTERY MANUFACTURER'S INSTRUCTIONS. TO ENSURE PROPER SAFETY AND OPERATION, BATTERY REPLACEMENT MUST ALWAYS BE DONE BY ADULT. Never let a child use this product unless battery door is secured. Batteries are small objects and could be ingested. Keep all batteries away from small children. Don't forget to remove batteries from the vehicle and remote control when you have finished operating your vehicle.

Remove all packaging before giving toy to child. Please keep packaging for future reference. Color, contents and designs may vary.

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be colocated or operating in conjunction with any other antenna or transmitter.
Alkaline batteries are recommended.

49MHz
HOW TO OPERATE Forward
Push the left control stick upwards.

Backward

Push the left control stick downwards.

Spin Turn left forward

To spin counterclockwise, keep pushing the right control stick to the left. To spin clockwise, keep pushing the right control stick to the right.
Push the left control stick upwards while pushing the right control stick left.

Turn right forward

Push the left control stick upwards while pushing the right control stick right.

Turn left and back

Push the left control stick downwards while pushing the right control stick left.

Turn right and back

Push the left control stick downwards while pushing the right control stick right.

1.5V "AA" x 2 1.5V "AAA" x 4

1 95464 533 1 1 6
392133-06695-729-050624

DISTRIBUTED BY

GREENBRIER INTERNATIONAL, INC.

Do not put in trash. Recycle or manage as hazardous waste.

500 VOLVO PARKWAY, CHESAPEAKE, VA 23320
MADE IN CHINA


Adobe PDF library 15.00 Adobe Illustrator 25.0 (Macintosh)