HY-3316
Multiple Function RGB Light Wireless Speaker
Components
- Wireless Speaker*1
- Charging Cable*1
Specifications
| Wireless transmission range: | up to 10 meter |
| Speaker drive size: | 3inch*2 |
| Output power: | 10W |
| Frequency response: | 100HZ-20KHZ |
| FM scan range: | 87.5-108.0MHz |
| USB charging: | TYPE-C |
| Product size: | 15*18.5*33CM |
The power delivered by the charger must be between min [2.5] Watts required by the radio equipment, and max [10] Watts in order to achieve the maximum charging speed.
Key Manual
The key manual diagram illustrates the controls and ports of the HY-3316 speaker.Top View: Features buttons labeled MODE, PREV, NEXT, PLAY/PAUSE, LED indicator, MASTER, and EHCO.Side View (Ports and Controls):1. USB Port2. POWER BUTTON (OFF/ON)3. AUX IN JACK4. TF/SD CARD slot5. CHARGING PORT6. CHARGING INDICATOR LIGHT7. MIC (Microphone)
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:- Reorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver.- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.- Consult the dealer or an experienced radio/TV technician for help.The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.