K71 Smart Watch User Manual

1. Product Introduction and Button Definition

Product Image: A smart watch with a black casing and orange strap.

Button Definitions:

Button 1 (Power Button):
- Short press: Enter application list or return to watch face, turn off screen.
- Long press (3 seconds): Power on/off, restart, reset.
Button 2 (Back/Shortcut Key):
- Short press: Return to previous level, light up screen, pause/continue exercise, mute incoming call.
- Long press (3 seconds): Activate voice assistant.
Button 3:
- Short press: Activate flashlight, light up screen.

2. Touch Screen Control Definition

Swipe down: Open status bar.
Swipe up: Enter notification information.
Swipe left: Enter card shortcut function.
Swipe right: Enter main menu.
Press and hold dial: Switch dials. Swipe left and right to select, then click to confirm.

3. Charging

Charge when the battery is low. Charging time is 2-3 hours.
The watch uses magnetic charging. Align the charging contacts.
The screen turns off during charging for stability. Press a button to wake the watch. If the battery is very low, it may take 3-5 minutes to wake up.
Use a charger with a rated output voltage of 5V and a current of 0.5A-2A, or a computer USB port.
For long-term storage, fully charge the watch and then turn it off. Do not store with a low battery.

4. APP Connection

Download and install the "FitCloud Pro" APP from your app market or by scanning the watch QR code.

Connection Steps:

Open the mobile phone APP and set personal information.
Switch to the "Device" page and click to bind the device.
Click your device in the scanned device list.
Confirm pairing when prompted on both the watch and mobile phone.

Connection Status:

Green call and data icons indicate a successful connection.
Red icons indicate disconnection.

Diagram: A flowchart showing the connection process: Scan Watch QR Code -> Open mobile phone APP -> Set personal information -> Switch to "Device" page and click to bind the device -> Click your device in the scanned device list -> Binding completed.

5. APP Unbinding

iOS: In the APP "Device" interface, click "Unbind". Then go to your phone's "Settings-Bluetooth", click on the device, and select "Forget this device".
Android: In the APP "Device" interface, click "Unbind".

6. Precautions

Do not charge in wet conditions.
This device is not a medical device; data is for reference only.
Avoid hot showers or saunas to prevent steam damage. Water damage due to improper use is not covered by warranty.
Do not expose the device to direct sunlight or high temperatures (e.g., car dashboards, near heat sources).
Keep away from children and pets to prevent swallowing or injury.
This is not a toy; children should use it under adult supervision.
The battery is built-in and non-removable. Do not attempt to replace it.
If the watch gets wet, wipe it dry immediately. If water remains in the speaker cavity, shake it out to maintain sound quality.

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to two conditions: (1) it may not cause harmful interference, and (2) it must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

If interference occurs, try the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment to an outlet on a different circuit than the receiver.
Consult the dealer or an experienced radio/TV technician.

The device has been evaluated to meet general RF exposure requirements and can be used in portable exposure conditions without restriction.