RDO DIGITAL Release Cord Mount Options
By default, the RDO DIGITAL Release Cord is set up vertically. If the site of installation requires a horizontal Release Cord set up for whatever reason, follow the instructions below to switch from the default Vertical Position to the Horizontal Position of the Release Cord.
Figure 1: Release Cord in the Vertical Position
Diagram showing the RDO DIGITAL unit with the release cord attached in a vertical orientation. The cord is routed through a loop and secured.
Figure 2: Remove the “E-Clip”
Close-up diagram showing the removal of an "E-Clip" securing the release cord mechanism. An arrow indicates the direction of removal.
Figure 3: Remove the Cable and Anchor
Diagram illustrating the removal of the cable and its anchor from the current position. The "E-Clip" is also visible.
Figure 4: Re-insert Cable and Anchor in New Position
Diagram showing the cable and anchor being re-inserted into a new mounting point on the RDO DIGITAL unit. The "E-Clip" is shown ready to be used.
Figure 5: Secure Cable and Anchor with “E-Clip”
Diagram showing the "E-Clip" being inserted into the new position to secure the cable and anchor.
Figure 6: Release Cord in the New Horizontal Position
Diagram showing the RDO DIGITAL unit with the release cord now attached in a horizontal orientation.
