Brandmotion AHD Dash Camera 1080P
Model: FLTW-1101
Vehicle Application: Universal
Recommended Tools & Installation Details
| Recommended Tools | Difficulty Level |
|---|---|
| ? Screw Driver ⚡️ Electrical Tape | ???? |
| ⏰ Install Time: 1hr 30m - 2hr | |
For questions, contact the Brandmotion technical support line at (734) 619-1250 or CLICK HERE.
Kit Contents
Components for installing the FLTW-1101:
A front-facing view of the Brandmotion AHD Dash Camera 1080P.
- 1x AHD Dash Camera
- 1x Camera trim piece
- 1x Cable cover
- 1x 4-pin to aviator 4-pin converter cable
Camera Mounting (Part 1)
Universal Camera Mounting
- Identify where to mount the camera on the front windshield.
- Clean the area with isopropyl alcohol.
- (Optional) If mounting under mirror mount, remove red 3M tape cover from the camera trim piece and press firmly into place.
- Remove the red 3M tape cover from the camera.
- Press the camera firmly against the windshield to adhere.
Images showing the camera being mounted to a windshield, including close-ups of the adhesive backing and placement.
Powering the Camera (Part 2)
Universal Camera Power
- Connect the 4-pin to 4-pin aviator cable to the camera. Tape the connection.
- Make the 4-pin connection to the display and tighten the screw connector.
- Tuck excess wire into the headliner.
- (Optional) Remove red 3M tape cover from wire cover and place over the exposed camera wire.
Images showing the 4-pin aviator cable connection to the camera and the cable tucked into the vehicle's headliner.
