TUCKER BARBECUES

Horizon 316 Marine Grade Stainless Steel Built-in

Barbecue Dimensions

Horizon 316 Marine Grade Stainless Steel Built-in

Tucker Horizon BBQ is made for Outdoor Use Only!

Please Note: Dimensions to be used as a guide only. All Customers MUST refer to the user manual supplied with the product for detailed installation instructions. Please allow sufficient clearance to combustibles. Please do not block any airways or vents. Sizes correct at time of printing. Measurements are subject to change.

Tucker BBQs can not be held liable for changes to product sizes/dimensions due to continual product upgrades. It is recommended you purchase your product prior to starting any building work involved with the installation of the product to make sure the sizes are correct.

Horizon with Roasting Hood Dimensions

Front and side views showing dimensions for the Horizon with Roasting Hood.

Overall Width: 924mm

Internal Width (between side panels): 796.5mm

Height (with hood closed): 468mm

Depth (front to back): 822.5mm

Height (with hood open): 768mm

Hood Height (closed): 48.5mm

Front panel to side clearance: 213mm

Front panel to base clearance: 69mm

Gas Manifold Height (from base): 67.8mm

Gas Manifold Depth (from front): 477.6mm

Gas Manifold Width: 518mm

Gas Manifold Depth (from rear): 26.2mm

Horizon with Flat Lid Dimensions

Front and side views showing dimensions for the Horizon with Flat Lid.

Overall Width: 924mm

Internal Width (between side panels): 776mm

Height (with lid closed): 761.8mm

Depth (front to back): 822.5mm

Front panel to base clearance: 67mm

Front panel to side clearance: 251.8mm

Internal depth (between side panels): 238.8mm

Gas Manifold Depth (from front): 477.6mm

Gas Manifold Width: 518mm

Gas Manifold Depth (from rear): 26.2mm

Flat lid height (closed): 35mm

Horizon Built-in BBQ Cut-out Dimensions Required when Built into Brickwork

Diagram showing a brickwork opening with dimensions for the BBQ cutout.

Brickwork Surround Width: 850mm

BBQ Opening Width: 495mm

BBQ Opening Height: 280mm

Minimum Clearances to Brickwork:

Top: 90mm
Sides: 50mm
Rear: 100mm

This installation requires a Non-Combustible Material surround.

Manifold Location on BBQ

The manifold is factory fitted at the back on the right-hand side. Manifold diameter is 20mm square tube.

The roasting hood is flush with the back of the BBQ when open. The flat lid is 35mm high when shut and 510mm high when open.

NOTE: Do Not place gas cylinder underneath the barbecue, keep required clearance and ensure there is 'permanent separation', i.e. no line of sight between the gas cylinder and combustions area. If the gas cylinder is enclosed, ensure adequate high and low ventilation (200 square cm each) as required by AS/NZS 5601.1

Clearances Surrounding BBQ

The minimum clearances from a Horizon BBQ to combustible material surrounding the BBQ are as follows:

Above the BBQ: 800mm
From the sides: 50mm
From the rear: 100mm

IMPORTANT: Allow fresh air to circulate into BBQ from underneath BBQ. Minimum air ventilation required underneath is 200 square centimeters.

For alternative types of installation, contact your nearest dealer.