Rear Floor Mat Package Installation

Kit Contents

Procedure

Step 1: Prepare Fasteners

Locate the mounting points and fasteners. The image shows a clip mechanism with fasteners labeled "1X" and "3X".

Step 2: Position Floor Mat

Prepare the vehicle's rear floor area. Position the floor mat as shown in the diagram, which illustrates two vehicle outlines and the floor mat placement.

Step 3: Manipulate Floor Mat

Manipulate the floor mat as depicted in the diagram. This may involve unfolding or preparing it for separation.

Step 4: Inspect and Cut (First Instance)

Inspect the floor mat. Follow the indicated cut line (shown as a yellow dotted line) for separation, using scissors if necessary. This step involves checking the mat and potentially cutting along a pre-defined line.

Step 5: Separate Floor Mat (First Instance)

Cut or separate the floor mat along the indicated line. Confirm the separation is correct with an "OK" checkmark.

Step 6: Fold/Position Floor Mat

Fold or position the separated floor mat pieces as shown in the diagram.

Step 7: Inspect and Cut (Second Instance)

Inspect the floor mat again. Follow the indicated cut line (shown as a yellow dotted line) for separation, using scissors if necessary. This is a repeat of the inspection and cutting process.

Step 8: Separate Floor Mat (Second Instance)

Cut or separate the floor mat along the indicated line. Confirm the separation is correct with an "OK" checkmark.

Step 9: Place Floor Mats

Place the separated floor mat pieces into the vehicle's rear footwell, aligning them correctly as indicated by the diagrams.

Step 10: Secure Floor Mats

Secure the floor mat by engaging the fasteners under the seat. The diagram shows clips being fastened.

Step 11: Final Check

Ensure all fasteners are properly engaged for a secure installation.