Instruction Manual for MBRP models including: S5090BLK, S5090 Cat Back Single Side 3 Inch Exhaust System for 2017-2022 Colorado or Canyon, S5090, Cat Back Single Side 3 Inch Exhaust System for 2017-2022 Colorado or Canyon
MBRP Armor BLK 3" Cat Back Single Side - 2017-2022 Colorado/Canyon 2.5L/3.6L | Thoroughbred Diesel
Figure 1 Figure 3 Removal of Stock System: 1. Apply a penetrating lubricant liberally to all hangers and rubber isolators. 2. Remove two flange nuts at the front flex pipe flange. Save the flange nuts as they will be used for the installation. Refer to Figure 1. 3. Remove the factory hangers from the rubber isolators and remove the factory system. Installation of MBRP Performance Exhaust: 1. The Front Pipe is supplied to fit the long wheelbase (CCLB) truck. If you have a short wheelbase truck (CCSB, ECLB) you will need to cut 12.25" off the Front Pipe. Refer to Figure 2. Figure 4 Figure 5 Figure 6 S5090 © 10/22 Figure 2. 2. Loosely install the Front Pipe using the supplied 3/8" Washers, factory flange nuts and rubber isolator. Take care to install the flange nuts equally. Refer to Figure 3. 3. Install the Tail Pipe into the factory rubber isolators. It may be easiest to remove one of the front isolators and install onto the Tail Pipe hanger first, then back onto the factory frame hanger. Refer to Figures 4 and 5. 4. Place a 3" Clamp over the Front Pipe and Tail Pipe. 5. Install the Muffler onto the Front Pipe then the Tail Pipe. Refer to Figure 6. PAGE 2 OF 3 Figure 7 6. Install the Exhaust Tip and adjust to your liking. Refer to Figure 7. 7. Tighten all hardware and clamps, starting at the front and working rearward to secure the system. Check along the full length of the exhaust system to ensure there is adequate clearance for fuel lines, vent lines, brake lines, frame, bodywork, suspension, and any wiring, etc. If there is any interference detected, relocate, or adjust to provide adequate clearance. Ensure all clamp connections are secure and components are unable to rotate or slide. Band clamps require approximately 45 lb-ft (60 N-m) of torque. Verify clearances, system security and band clamp torque after 30-60 miles (50-100 km) of driving. Congratulations! You are ready to begin experiencing the improved performance and driving pleasure of your MBRP Performance Exhaust system. We know you will enjoy your purchase. S5090 © 10/22 PAGE 3 OF 3Microsoft Word for Microsoft 365