Instruction Manual for Runleader models including: XBI003BM60AA, 2A7PCXBI003BM60AA, XBI003BM60AA Digital Tach Hour Meter, Digital Tach Hour Meter, Tach Hour Meter, Hour Meter
NingBo JiangBei Run Leader Electronics Co.,Ltd XBI003BM60AA Battery indicator & Hour meter & Bluetooth Controller 2A7PCXBI003BM60AA 2A7PCXBI003BM60AA xbi003bm60aa
File Info : application/pdf, 2 Pages, 1.16MB
DocumentDocumentAPP Operating Instruction 3. QR Code Download: 4.Official Download }Product Function Settings~ Open the APP "Moresee", click the " " icon after the product is successfully connected, find the "Using Help" and click "Using Help" to open the Runleader website. Then find the product function manual, and user can download and refer to the manual to set the function parameters. Battery indicator & Hour meter & Bluetooth Controller Scan the official QR code of "Moresee" with the mobile phone to download and install. http://www.runleader.com Find the "Moresee" QR code on the official website "DOWNLOAD" to scan, download and install. or Please read and understand the following notices carefully, and correctly install and operate the product before using. Notice 1. Please refer to the installation and function instructions in the APP operation manual to avoid damage caused by installation errors. 2. If instrument failure or malfunction may cause personal injury or material damage, use additional safety measures such as limit switches, guards, etc. 3. Do not pull the wire when using to avoid falling off or poor contact. 4. Please install the product in an appropriate location to avoid this product being hit and prevent damage to the product. 5. This product is waterproof to some extent, but can not be used in deep water or long-term immersion in rain water. 6. Please use this product at the specified temperature, the high temperature environment may cause damage to the product. }APP Installation~ Four ways to download: 1. IOS APP Download: 15:53 Moresee 5G 49 × Cancel Moresee Utilities OPEN 2. Android Download: 15:53 5G 49 Moresee Runleader 3 Rated for 3+ Install }Product Connection~ Bluetooth binding method: a) Turn on the Bluetooth function of your mobile phone, open the app to add a device, look for nearby devices and find the product you are connected to. b)The product in the correct state of power connection, the LED displays the current battery voltage gear, click the icon after selecting the desired product through the APP search, and then wait for 5 seconds the APP interface is automatically bound successfully, and automatically jump to the APP interface "Start use", which means that the Bluetooth connection is successful. Home ALL Add manually Devices nearby Binding Please avold powering off the device during the binding process,and keep the phone close to the device No device Add device can't find devices to add?View help Device name Choose device place Motorcycle Motorcycle Conected succeeded BATTERY VOLT W Search "Moresee" in "App Store" to download and install Search "Moresee" in "Google Play Store" to download and install. Start to use Motorcycle Conected succeeded BATTERY VOLT W XBI003BM60AA Mac: 01:B9:FE:00:01:15 Firmuware upgrade Reset Feedback Help Technical support 057455122682 E-mail coywei@runleader.ocm Purchase link http://www.runleader.com Remove device Help https://www.runleader.com/index.php/ product/info/225.html FCC warning: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) this device must accept any interference received, including interference that may cause undesired operation. }Product Specification~ ITEM NAME Product model LED color selection LED display mode Working mode Discharge mode Charging mode Discharge mode up Charging mode down Charging delay Low battery reminder Battery type Voltage range Voltage display accuracy Operating voltage Working current Display window size (Visible) Product Size Housing material Waterproof rate Product weight PARAMETERS XBI003BM60AA All green - All red Multiple(default) Full display (default) Single display Only fall not rise Rise or fall Gear by gear discharge Gear shift discharge Up step by step One-time full charge 0-255s; Default 15s 0-255s; Default 15s Charging gear by gear 0-50000s, default 20s; One-time full charge 0-50000s, default 20s 10%-60%, Default 10% 8 kinds +1 group custom DC 12V 24V 36V 48V ±5%, 0.01V DC 8~65V 20mA nominal 25.5×7.6mm 53.1×31.1×34.8mm PC545 IP67 About 27g 31.1 31.1 7.6 7.6 }Product Dimension~ XBI003BM60AA 53.1 25.5 35.5 17.5 XBI003BM60AA 53.1 25.5 35.5 17.5 34.8 23.2 36 PANEL CUT OUT R2 24 Unit:mm 34.8 23.2 36 PANEL CUT OUT R2 24 Unit:mm