Head Hunting, Selezione del Personale ed Executive Search - Bologna
PDFs ändern, bearbeiten, zusammenfügen und editieren mit dem Editor
User Manual for Shantou Zhengfang Toys models including: ZF04, 2AY6S-ZF04, 2AY6SZF04, ZF04 Four Axis Aircraft, Four Axis Aircraft
SHANTOU ZHENGFANG TOYS CO., LTD ZF04 FOUR AXIS AIRCRAFT 2AY6S-ZF04 2AY6SZF04 zf04
File Info : application/pdf, 2 Pages, 252.63KB
DocumentDocument3.Keep away from water. 4.Regular check is suggested and damaged parts shall be replaced in time. SAFETY REGULATIONS 1.Small parts shall be well kept far away from children. 2.It is suggested to power up slowly to avoid any potential damage of high speed. 3.It is suggested to switch off the power of the remote controller before the quadcopter. 4.The batteries shall be kept away from fire or high temperature. 5.The quadcopter shall be kept an enough distance from others to avoid any potential injury. 6.Child shall be under the monitoring of an adult in playing the quadcopter. 7.It is prohibited to charge a non-chargeable battery.Batteris shall be installed in correct direction.It is not allowed to use the old battery and the new battery at the same time. 8.The switches shall be shut down and the batteries shall be taken out for long time no use. 9.Be aware of the risk of short circuit. CAUTION 1.Insufficient electricity power will shorter the control distance. 2.Insufficient electricity power will lead to diffculties in taking off and ascending. 3.Fix the quadcopter in time if there is any damage.If it is damaged badly (for example:blade is damaged),it may hurt players. 4.Remove the transmitter batteries if not in use for along time in case of battery leakage. 5.Avoiding dropping and crashing the quadcopter for it will lead to damages and shorten the use life. 6.The alloy parts in the quadcopter may hurt you children,please pay much attention. PdfEditor 4.0.0.14 Testversion - https://www.pixelplanet.com/de 4 FCC Statement This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ·Reorient or relocate the receiving antenna. ·Increase the separation between the equipment and receiver. ·Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ·Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. PdfEditor 4.0.0.14 Testversion - https://www.pixelplanet.com/de/pdfeditor/