Installation Guide for diyversify models including: 2024 Freestanding Straight Partition Wall with Door, 2024, Freestanding Straight Partition Wall with Door, Straight Partition Wall with Door, Partition Wall with Door, Wall with Door
Assembly Guides – Diyversify
Freestanding Partition Wall With Door | Free Shipping | ⭐️ 4.8 Rating – Diyversify
File Info : application/pdf, 13 Pages, 477.17KB
DocumentDocumentdiy versify ASSEMBLY GUIDE FREESTANDING STRAIGHT PARTITION WITH ACCORDION DOOR diy versify www.diyversify.com +1 855-348-4330 WHATS INCLUDED diy versify Wall Panels Door-Kit Finishing Caps Two-Way connectors TOOLS NEEDED Not Included Lug Connectors 1. Inspect your order thoroughly prior to installation (contact us with any issues) a. Make sure that shipment have not damaged any of the panels. b. Make sure you have all the items listed out in your "item list" (sent by email). 2. Grab a friend (optional) We always recommend having another person there to help you with kits higher than 4'f to help hold panels in place and avoid any pinch points. Page | 1 diy versify BEFORE GETTING STARTED Minimum 2in Gap 1. Positioning Panels in Their Approximate Location Roughly lay out flat against the floor a single layer of wall panels outlining the configuration of your wall. This will give you a good overview of how everything fits together. Make sure to take into account the 3' width for the door 2. Make sure the surface area you are building in is level This is important, as bottom panels will not be able to connect with each other if the floor is too uneven. For any issues or questions regarding assembly our team is here to help you Monday-Friday 9AM-5PM (EST) diy versify www.diyversify.com +1 855-348-4330 Page | 2 diy versify 1 Two-Way Connectors 2 Two-Way Connectors Two-Way Connectors Two-Way Connectors Page | 3 diy versify 3 Two-Way Connectors Two-Way Connectors Page | 4 4 diy versify Lug Connectors Insert a lug connector in every 2-3 hole. DO NOT insert lugs in every connector hole. Doing so will create a gap between panels. Page | 5 diy versify 5 Page | 6 diy versify 6 Finishing Caps Close off exposed connector holes 1. Use the included finishing caps to close of the exposed connectors holes at the corner Simply insert the finishing caps into the open connectors until you hear a click 2. Close off the connector holes in the door frame, to prepare for installing the door This is necessary to attach the door frame. Note The finishing caps can be challenging to get out once installed, so make sure to save this step for last when you have confirmed everything looks good. Page | 7 diy versify 7 DOOR INSTALLATION Place door lintel track on top of walls, and use two-way connectors to attach lintel to walls. Slide door into lintel track Page | 8 8 Two-Way connectors 9 diy versify Fasten door support clips on the side you want the door fixed to Page | 9 10 diy versify Receiver channel Tighten fully with a screwdriver Page | 10 11 diy versify Insert 2 door handle pins into one door handle and slot the pins through holes on door panel unit. Attach the other side of the door handle to the pins and squeeze together. Page | 11 12 diy versify Fasten magnetic plate on receiver channel diyversify We are available for assembly support via chat, phone or email Monday-Friday 9AM-5PM (EST) hello@diyversify.com +1 855-348-4330 Page | 12