RC-PRO Shredder Brushless Manual

Contents

Instructions

Thank you for purchasing the SHREDDER BRUSHLESS monster truck. Please read all instructions and warnings carefully before operating. Please also keep this instruction manual for future reference and maintenance.

IMPORTANT:

1. This monster truck is not a toy. It may cause injury or damage if not used properly under a controlled environment. Always make sure you practice driving in an open airspace area while following the rules and regulations which apply to the area to avoid any potential damage or injury.
2. This product is suitable for experienced drivers no less than 14 years of age.

BEFORE YOU PROCEED

Please read carefully and follow all instructions. Violation of these instructions shall be deemed as misuse or faulty operation. Before operating your remote-controlled car, please read all contents of this manual and check carefully the remote car. The dealer shall not support return & exchange after the remote-controlled car is unpacked or used.

Safety Precautions

PAY ATTENTION TO SAFETY PRECAUTIONS

! Warning: Do not modify or alter this model. Changes or modifications to this model not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

• The truck is suitable for ages 14 and above. Parents should supervise children who operate the truck.
• This truck is suitable for indoor or outdoor use.
• Switch off the truck and disconnect the battery when not in use.
• Keep hands, face and loose clothing away from the truck.
• Always follow these instructions when operating this truck.
• Do not operate near people or animals.
• Always unplug battery from charger after charging is complete. Disconnect the charger from the power source and only then disconnect the battery from the charger.
• DO NOT store the truck in a damp environment. The truck's interior is composed of delicate electronic components and mechanical parts, which can be seriously damaged by moisture. Please take serious care, as this type of damage may not be visible on the outside, but can cause the product damage or act unpredictably once in use.
• Always operate with safety in mind. DO NOT use this truck under the influence of drugs or alcohol, or in the case of fatigue, as improper operation can cause serious injury and/or property damage.
• DO NOT store or operate in high heat, as electrical components can be damaged.
• Small parts are included with this product. Please place it beyond the reach of the children to avoid a CHOKING HAZARD or parts being mistakenly swallowed.
• Only the original charger made from our factory can be used.
• Charger is not a toy.
• Engine will heat up. Please DO NOT touch it to avoid being burned or injured.
• Always operate your truck within eye sight.
• RC-PRO's all-weather electronics allow you to operate your truck in various conditions, including rain, snow, mud and more. DO NOT submerge your RC-PRO Truck!

Rechargeable Battery

Connect the truck battery to the charger. Plug the charger into a power outlet and fully charge (about 6 hours). DO NOT LEAVE CHARGING BATTERY UNATTENDED. The green LED light on the USB charger will flash as long as the battery is charging. The light will turn to solid green once the battery is full. The battery may be warm when charging is complete. Disconnect the charger from the outlet, then the battery from the charger.

Battery Precautions

• Non-rechargeable batteries cannot be recharged.
• Do not dismantle or short circuit batteries.
• Keep batteries away from heat and flame.
• Charge rechargeable batteries under adult supervision.
• Remove rechargeable battery from truck before charging and when not in use.
• Remove battery before cleaning.
• Regularly check all wires, plugs and batteries to ensure proper performance and safety. In case of damage discontinue use until repair.

Lithium Battery Safety Precautions

Our company is not liable for any damages incurred by the appropriate or inappropriate use of this product.

! Warning: Check all batteries before charging and before use. Do not use or charge damaged batteries. Do not over-charge batteries. Keep batteries away from heat and flame. Lithium is highly reactive with water; always keep batteries away from water and humid conditions. Keep out of reach of children and pets. Product should not be used by persons under 14 years of age, and should be accompanied by an adult until 18 years of age. Our company is not liable for any damages resulting from improper use or handling of the product.

! WARNING: CHOKING HAZARD - Small parts. Not for children under 3 years.

WARNING: Product should only be used by adults and children 14 years and older. Adult supervision required for children under 14 years of age.

! WARNING: CHARGING OF THE TRUCK BATTERY MUST BE SUPERVISED AT ALL TIMES BY AN ADULT. UNPLUG THE BATTERY WHEN FULLY CHARGED. DO NOT OVER-CHARGE THE BATTERY.

Product Packaging Content

• SHREDDER BRUSHLESS X1
• Remote X1
• 7.4V 4000mAh Lipo Battery X1
• USB Charger X1
• Extra Parts Kit X1
• Socket Wrench X1
• Manual X1

Product Specification

Model Introduction

A detailed diagram shows the various parts of the SHREDDER BRUSHLESS monster truck:

• High-traction tire
• Front control arm
• Bright LED lights
• Front bumper
• Front body mount
• Spring preloading adjuster
• Shock absorber
• Battery
• Toe angle connecting rod
• Chassis
• Motor
• Electronic speed control
• Switch
• Receiver
• Transfer
• Push rod
• Rear control
• Toe angle connecting rod
• Rear bumper
• Rear body mount
• Shock absorber

Ready for Play

Installation of Remote Battery

Your remote requires three AA batteries (No.5). The battery compartment is at the bottom of the remote.

1. Hold and slide the battery compartment to take off the battery compartment cover.
2. Install the battery according to correct directions of positive and negative anodes, indicating on the battery compartment.
3. Re-install and close the battery compartment.

Turn the remote power on to check its state indicator light with red. Once the remote control is paired with the truck, the indicator light will remain solid and the truck is ready to go.

The remote's LED indicator light will flash slowly in case the AA batteries are too weak. In this case, please change to fully charged AA batteries.

If the LED indicator of the remote is off, please check the direction of the positive and negative anodes and check whether the battery is charged fully. Please refer to the diagram of Identification number on page 9 for any other flash signals from LED.

Use normal battery

Your remote control uses AA batteries which are not included in this package. You can also use rechargeable batteries in your remote. Please make sure that rechargeable batteries are charged fully according to instructions of manufacturers. If you use rechargeable batteries in your remote, you should know that their power is consumed quickly compared with other alkaline batteries.

Note: When your remote-control's batteries voltage reaches low levels (red light flashes slowly), please stop running the truck immediately in order to avoid damage or injury due to signal loss.

Install the Battery Pack for Your Model

Your SHREDDER BRUSHLESS comes with an included 7.4V Lipo Rechargeable Battery pack. Please install the battery according to the following steps:

1. Remove the truck's cover.
2. Remove the buckle that holds the battery cover.
3. Place the battery in the designated compartment and make sure the wires are positioned towards the front of the car.
4. Replace the battery cover, re-install the buckle and make sure the battery wire is not being pinched.

WARNINGS: LiPo batteries are only suitable for advanced users who have been aware of battery risks. It is not recommended that children below 14 years old operate LiPo batteries with direction of experienced adults. Please strictly obey directions from battery manufacturers and charger manufacturers charge, and it is important for you and users of this product to use and store LiPo batteries. Be sure your safety and understand how to use LiPo battery. Please notice that our company has no obligations to install batteries of the model, therefore, we will assume liability of any special, non-direct, attached or indirect loss caused by using LiPo battery.

Note of Remote Operation

This 2.4G remote is equipped with directional antenna. In order to obtain maximum distance, please hold the remote vertically towards the model.

Pairing

1. Install the battery into the truck and secure battery strap to post using clip.
2. Connect the battery.
3. Switch remote control on.
4. Switch Truck on.

Make sure you switch the truck on within 20 seconds of switching on the remote-control. If you are using more than 1 truck then in order to avoid signal interference, always pair 1 truck at a time. Continue to pair a second truck only after pairing is completed.

The SHREDDER BRUSHLESS utilizes 2.4 GHz wireless remote control technology.

2.4GHz Remote

Remote Controller

The remote controller features:

• Throttle dual rate
• Steering dual rate
• Steering trim
• Steering reverse switch
• Power switch
• Power indicator
• Throttle reverse switch
• Steering
• Throttle

Remote LED Codes