No. | Setting | Description | Values |
---|---|---|---|
0 | SQL | Squelch Level | 0 > 9 |
1 | STEP | Frequency Step | 2.5 / 5 / 6.25 / 10 / 12.5 / 25 kHz |
2 | TXP | Transmit Power | High / Low |
3 | SAVE | Battery Save | 1:1 1:2 1:3 1:4 |
4 | VOX | Voice Operated Xmtr | OFF / 0, 1, 2 > 10 |
5 | WN | Wideband / Narrowband | WIDE / NARR |
6 | ABR | Display Illumination Time | OFF / 1 / 2 / 3 / 4 / 5 seconds |
7 | TDR | Dual Watch / Dual Reception | OFF / ON |
8 | BEEP | Keypad Beep | OFF / ON |
9 | TOT | Transmit Timer | 15 / 30 / 45 > 600 seconds |
10 | R-DCS | Rec - Digital Coded Squelch | OFF / D023N > D754I |
11 | R-CTCS | Rec - Continuous Tone Coded Squelch | 67.0 Hz > 254.1 Hz |
12 | T-DCS | Trans - Digital Coded Squelch | OFF / D023N > D754I |
13 | T-CTCS | Trans - Continuous Tone Coded Squelch | 67.0 Hz > 254.1 Hz |
14 | VOICE | Voice Prompt | OFF / ON or OFF / ENG / CHI |
15 | ANI-ID | Automatic Number ID of Radio (set with S/W) | |
16 | DTMFST | DTMF Tone of trans code | OFF / DT-ST / ANI-ST / DT+ANI |
17 | S-CODE | Signal Code (set with S/W) | 1 > 15 groups |
18 | SC-REV | Scan Resume Method | TO / CO / SE |
19 | PTT-ID | When to send the PTT ID signal code | OFF / BOT / EOT / BOTH |
20 | PTT-LT | Signal Code sending delay | 0 > 30 ms |
21 | MDF-A | Channel Mode A Display | FREQ / CHAN / NAME |
22 | MDF-B | Channel Mode B Display | FREQ / CHAN / NAME |
23 | BCL | Busy Channel Lockout | OFF / ON |
24 | AUTOLK | Automatic Keypad Lock | OFF / ON |
25 | SFT-D | Frequency shift direction | OFF / + / - |
26 | OFFSET | Frequency shift amount | 00.000 > 69.990 MHz |
27 | MEM-CH | Store a memory channel | 000 > 127 |
28 | DEL-CH | Delete a memory channel | 000 > 127 |
29 | WT-LED | Illumination / Display Color - Standby | OFF / BLUE / ORANGE / PURPLE |
30 | RX-LED | Illumination / Display Color - Receive | OFF / BLUE / ORANGE / PURPLE |
31 | TX-LED | Illumination / Display Color - Transmit | OFF / BLUE / ORANGE / PURPLE |
32 | AL-MOD | Alarm Mode | SITE / TONE / CODE |
33 | BAND | Band Selection | VHF / UHF |
34 | TDR-AB | Transmit selection while in dual watch / reception | OFF / A / B |
35 | STE | Squelch Tail Elimination | OFF / ON |
36 | RP-STE | Squelch Tail Elimination through a repeater | OFF / 1, 2, 3 > 10 |
37 | RPT-RL | Delay the squelch tail of repeater | OFF / 1, 2, 3 > 10 |
38 | PONMSG | Boot / Power On Display Message | FULL / MSG |
39 | ROGER | Tone at end of transmission | OFF / ON |
40 | RESET | Restore to default settings | VFO / ALL |
![]() |
BAOFENG UV-5R User Manual Comprehensive user manual for the BAOFENG UV-5R two-way radio, covering safety, features, installation, battery management, operation, advanced functions, technical specifications, troubleshooting, and warranty information. Optimize your UV-5R experience with this detailed guide. |
![]() |
Baofeng UV-5R CHIRP Configuration Guide A comprehensive guide detailing the various settings and parameters for the Baofeng UV-5R radio, including frequency, squelch modes (CTCSS, DCS), duplex options, power levels, and scanning features, optimized for use with CHIRP software. |
![]() |
BaoFeng BF-UV5R Programming Guide A comprehensive guide to programming the BaoFeng BF-UV5R dual-band amateur radio using both the manufacturer's software and CHIRP. Covers system requirements, cable setup, software installation, and detailed parameter explanations for radio customization. |
![]() |
BAOFENG UV-5R VHF/UHF FM Transceiver User Manual Comprehensive user manual for the BAOFENG UV-5R VHF/UHF FM Transceiver, covering operation, features, battery care, troubleshooting, and programming. Learn how to use this dual-band, dual-watch amateur radio with CTCSS/DCS, VOX, and DTMF functions. |
![]() |
Baofeng UV5R i UV5RA: Rozszerzona instrukcja obsługi i programowania Szczegółowa instrukcja obsługi i programowania dla dwupasmowych transceiverów VHF/UHF FM Baofeng UV5R i UV5RA z cyfrowym systemem obróbki sygnału DSP. Zawiera informacje o funkcjach, bezpieczeństwie, instalacji akcesoriów, obsłudze podstawowej i zaawansowanej, systemach CTCSS, DCS, DTMF oraz dane techniczne. |
![]() |
Baofeng UV5R CHIRP Programming Software Guide and Features Learn about CHIRP programming software for the Baofeng UV5R radio, including features, installation instructions for various operating systems, and frequently asked questions. Discover how CHIRP enhances radio programming beyond factory software. |
![]() |
BaoFeng BF-88A Programming Guide: How to Program Your UHF Radio Learn how to program your BaoFeng BF-88A UHF radio using either the manufacturer's software or CHIRP. This guide covers setup, connections, and parameter adjustments for optimal performance. |
![]() |
Baofeng UV-7B Amateur Radio User's Manual Comprehensive user's manual for the Baofeng UV-7B Amateur Radio, covering setup, operations, features, and troubleshooting. |