User Manual for PROAIM models including: P-OHCP-01 3ft Overhead Platform, P-OHCP-01, 3ft Overhead Platform, Overhead Platform, Platform
User Manual
1 3ft Overhead Platform (P-OHCP-01) Assembly Manual What's In The Box Please inspect the contents of your shipped package to ensure you have received everything that is listed below. 1 x Cross Bar 2 x Side Bars 2 x Locking Pins 2 x Foot Joints 2 x L-Brackets 2 x Plastic Clips 1 x Camera Mount 4 x Support Bars 8 x M5 Short Thumb Screws 9 x Foot Thumb Screws All rights reserved. No part of this document may be reproduced, stored in a retrieval system, or transmitted by any form or by any means, electronic, mechanical, photo-copying, recording, or otherwise, except as may be expressly permitted by the applicable copyright statutes or in writing by the Publisher. 2 3ft Overhead Platform Setup Side Bar Assembly · Slide the Side Bar onto the ground foot. Lock the Side Bar to the foot using of the 1/4-20 Foot thumbscrew. · Similarly, Repeat Same Steps for attaching 2 feet. Support Bar Assembly · Assemble the Support Bar on the Side Bar using the long M5 Short knob. · Assemble the Support Bar on the foot using the short M5 short knob. · Repeat this step for the other support bar assembly, as shown in the image. 3 Camera Mount Assembly · Slide the Camera Holder onto the Cross Bar. · Adjust the height of the Cross Bar by sliding it along the Side Bar and locking it into position using the 2 Height Adjustment Thumbscrew. NOTE: Camera Platform slide on crossbar as per your requirement. Cross Bar Assembly · Attach the cross Bar with Side Bars as shown in image. NOTE: The Overhead Platform's crossbar is up/down adjustable & easily mounts through rosette knobs. The Camera Holder with a ¼"-20 screw can be locked into any position on the crossbar. · Then locking it into position using the 2 Height Adjustment Thumb screw. · To make the cross bar extra secure, properly secure it with the help of a pin. 4 · Similarly. Follow the same process to secure the cross bar to both sides. · You can adjust the height of the crossbar according to your shooting needs. as shown in image. L-Bracket Assembly · Attach the 2 L-brackets using the thumb screws onto the cross bar. · Both L-brackets is properly attached with cross bar. · Clamp your backdrop to the brackets using the 2 clips. NOTE: The backdrop & other Related Accessories is not included with the Overhead Camera Platform. 5 YOUR PROAIM 3FT OVERHEAD PLATFORM ALL DRESSED UP AND READY TO GO! (SHOWN WITH OPTIONAL ACCESSORIES) Warranty: We offer one year warranty for our products from date of purchase. Within this period of time, we will repair it without charge for labor or parts. Warranty doesn't cover transportation costs nor does it cover a product subjected to misuse or accidental damage. Warranty repairs are subjected to inspection and evaluation by us. Liability: We are not liable for damage caused by products that we do not supply or from mishandling in transit, accident, misuse, neglect, lack of care of the product, or service by anyone other than our company. Contact Us: In case of any kind of dissatisfaction, please Contact us immediately and we promise our utmost support and care until you use our product.Microsoft Publisher 2019