Pool Blaster Aqua Broom Turbo
Operator Manual
This manual provides instructions for the Water Tech Pool Blaster Aqua Broom Turbo, a cordless pool and spa vacuum. It covers operation, safety, maintenance, and warranty information.
Important Safety Instructions
READ AND SAVE THESE INSTRUCTIONS
WARNING: Read carefully and understand all safety warnings before operating. Failure to do so may result in serious personal injury.
AVERTISSEMENT: Lisez attentivement et comprenez tous les avertissements de sécurité avant de l'utiliser. Ne pas le faire peut entraîner des blessures graves.
ADVERTENCIA: Lea atentamente y comprenda todas las advertencias de seguridad antes de operar. De lo contrario, puede ocasionar lesiones personales graves.
General Warnings
- Never allow children to operate this product; it is not a toy.
- Keep the cleaner and accessories out of reach of children.
- Do not use or store the USB charging cord outdoors.
- Exercise caution and common sense when using the cleaner.
- Do not expose to liquid, vapor, or rain. Store in a clean, dry place away from direct sunlight or extreme temperatures.
- Do not plug or unplug the USB charging cord with wet hands.
- Do not operate in the presence of flammable or combustible liquids.
- Never service the cleaner while it is on or connected to the USB charging cord.
- Keep proper footing and balance; do not overreach.
- Disconnect from AC outlet before cleaning. Use a moisture sheet or cloth for cleaning; do not use liquid or sprayed detergent.
- Contains rechargeable batteries; do not incinerate. Dispose of batteries according to local law.
- Keep hair, loose clothing, and body parts away from openings and moving parts.
Specific Dangers & Hazards
- DANGER! RISK OF FIRE OR ELECTRIC SHOCK: Follow all instructions carefully.
- DROWNING HAZARD: This device produces suction. DO NOT use when bathers are present. Never permit children or non-swimmers to use this product.
- DANGER! WATER CONTACT HAZARD: DO NOT allow water or other conductive fluids to contact the USB charging cord or charging jack before or during charging. Pool water is corrosive and can cause short-circuits, smoke, fire, or injury. Ensure all charging surfaces are dry.
- WARNING! CHARGING REQUIRES ADAPTER (NOT INCLUDED): Use a 5.0V DC, 1.0A adapter. Use CE-certificated for EU, or Class 2/LPS certified for US/Canada.
Safety Symbols
- ❗ DANGER!: Indicates a hazardous situation that could result in death or serious injury if not avoided.
- ⚠️ WARNING!: Indicates a hazardous situation that could result in death or serious injury if not avoided.
- ⚠️ CAUTION!: Indicates a hazardous situation that could result in minor or moderate injury if not avoided.
- ❗ SAFETY ALERT: Indicates a potential personal injury hazard. Follow basic precautions.
- ? DO NOT GET WET: Indicates that water should not touch the indicated part. Failure to comply may result in minor or moderate injury.
- ? CHARGE FOR 4 FULL HOURS: Indicates the required charging time.
- ♻️ BATTERY RECYCLE: Recycle batteries according to local law.
- ?️ DISPOSAL: Dispose of unwanted product according to local law.
- CE: European Conformity.
- RoHS: Restriction of Hazardous Substances Compliance.
Product Breakdown
Model: 14101AL
- 1. Vacuum Head (P14X006) - The part that cleans the pool/spa floor.
- 2. Head Cover - Covers the vacuum head.
- 3. Filter Bag (P10XAP) - Collects debris.
- 4. Power Head - Contains the motor and battery.
- 5. Battery Chamber (P14X003LI) - Houses the rechargeable battery.
- 6. Pool Pole (Set of 4) (P15X4PC) - Extendable poles for reaching deeper areas.
- 7. USB Charging Cable (1S-CBL-01SQ) - Cable for charging the unit.
Charging the Battery
Requirements:
- Requires a USB charging adapter (not included) with specifications: Input 100-240V AC, 50-60Hz; Output 5.0V DC and 1.0A.
- For EU market, use a CE-certificated adapter.
- For US and Canada market, use a Class 2 type adapter certified by North American standards.
Charging Process:
- Ensure the charging receptacle on the product is dry before charging.
- Initial charge: 4 hours.
- Recharging (after complete discharge): 4 hours.
- Maximum charging time should not exceed 24 hours.
- Recommended charge temperature: 50°F (10°C) to 100°F (37.7°C).
Operation
Turning the Unit ON / OFF
Press the ON/OFF button. Submerge the cleaner immediately after turning it ON to protect the motor shaft seal. Failure to do so may shorten the life of the water seal and void the warranty.
Usage Guidelines
- Use only for its intended purpose: routine pool and spa maintenance. Not for pool openings.
- Designed for underwater use in pools or spas only.
- Avoid picking up sharp objects that may damage the filter.
- Keep all openings free of debris to maintain water flow.
- Keep proper footing and balance at all times.
- Recommended water temperature range: 40°F (5°C) to 96°F (35°C).
- Maximum operation depth: 12 ft (3.5 m).
Maintenance
Cleaning the Filter Bag
- Remove and clean the filter bag after each use.
- Rinse the bag without scrubbing it against itself.
Long Term Storage
- Always clean the head cover and filter bag before storing.
- Store and charge the cleaner in a cool, dry indoor shelter.
- Recharge the cleaner for 4 hours after each month of inactivity.
- Never leave the USB charging cord connected to the cleaner for more than 24 hours.
Limited Warranty
Water Tech Corp warrants this product against defects in material or workmanship.
- Pool Blaster Battery Powered Pool & Spa Vacuums: One (1) year from the original date of purchase.
- Accessories: Ninety (90) days from the original date of purchase.
To Obtain Warranty Service:
- Visit www.wtrma.com to obtain a Return Merchandise Authorization (RMA) number.
- Contact Water Tech Customer Support at (732-967-9888) or customerservice@watertechcorp.com for assistance.
- Package the unit and charger securely with the RMA number clearly marked. Ship to Water Tech Corp, 10 Alvin Court, East Brunswick, NJ 08816.
Limitations:
- Warranty applies only if purchased from an authorized Water Tech dealer.
- Water Tech is not liable for incidental or consequential damages.
- Implied warranties are limited to the duration of this warranty.
End of Life Disposal & Recycling
Battery Disposal
The Lithium Ion battery must be disposed of according to State and local law. Contact your local authority for recycling information.
- WARNING: Never attempt to disassemble a battery pack. Remove personal metal items when handling. Batteries can generate gases that may ignite. Do not expose to fire or intense heat.
- CAUTION: If a battery leak develops, avoid contact with leaking acid. Place damaged battery in a plastic bag. If acid contacts skin or clothing, wash immediately with soap and water. If acid contacts eyes, flush with cool water for at least 15 minutes and seek medical attention.
Product Disposal
Please respect European Union (WEEE) and US environmental regulations. Return non-working electrical equipment to a designated recycling facility. Do not dispose of in unsorted waste bins. For items with removable batteries, remove batteries before disposal.
Contact Information
Water Tech Corp
10 Alvin Ct., Suite 111
East Brunswick, NJ 08816 - USA
Tel: 732-967-9888 (US, Canada & International)
Fax: 732-967-0070 (US & International)
Website: www.WaterTechCorp.com
Register your product at: www.watertechcorp.com/register
For service and parts, call the number above.