Smart Light Controller-Dimmer Quick-start Guide

Introduction

Works with energy efficient dimmable light bulbs:

Electrical rating: 120V~ 50/60Hz

Supported Bulb Types

• Dimmable LED — up to 200 W
• Dimmable CFL — up to 200 W
• Halogen — up to 300 W
• Incandescent — up to 300 W

NOTE: You can mix and match dimmable LED and CFLs as well as halogen and incandescent light bulbs with Lamp dimmers. Dimmable LED and CFL light bulbs vary in their dimming performance. If you're using these bulbs and they flicker or turn off, please choose to replace the dimmer bulb that matches.

Important Notes

• For indoor use only.
• Operate between 32 °F (0°C) and 104 °F (40 °C).

1 Wiring Mode

⚠️ Turn off the power when operating

Wiring Connections:

• AC IN Live Wire
• AC IN Nature Wire
• TO Light Load
• TO Light Nature Wire

2 RF Remote Control Learning

Step 1: Press and hold the "Learning" button on the controller for 3 seconds until the LED and the light starts blinking.

Step 2: Press and hold the "Learn" button on the remote for 2 seconds until the light flash.

[Visual: A light bulb icon flashes once (x1).]

Repeat steps to pair other remote controls.

2 RF Remote Control Clearing

Press and hold the "Learning" button on the controller for 10 seconds until the LED and light flash 2 times. This clears all paired remotes and app connections.

3 Link to Amazon Echo

[Visual: "Works with Amazon Alexa" logo.]

Find Device command:

• "Alexa, discover new devices"
• "Alexa, discover the devices"

Common commands:

• "Alexa, set the bedroom light to fifty percent."
• "Alexa, turn on bedroom light."
• "Alexa, turn off first light."

4 Troubleshooting

Warning

⚠️ Use only with permanently installed fixtures with dimmable LED, dimmable CFL, halogen, or incandescent lamps.

To avoid overheating and possible damage to other equipment, do not use to control motor-driven appliances, or transformer-supplied appliances.