Nordlux 3-Step Moodmaker Installation Guide

How it Works

This light fixture operates in a 3-step dimming mode controlled by a standard wall switch. By turning the switch on and off in specific sequences, you can select different brightness levels:

• Turning the switch ON/OFF quickly cycles through brightness levels: 30%, 70%, 100%.
• If the light is turned ON for 7 seconds or more, it will remember and repeat the last selected setting when turned on again.

Installation Instructions

Mounting Dimensions

The fixture requires specific mounting dimensions: 8.2cm height, 3cm depth, and a hole diameter of Ø1.2cm.

Mounting Steps

Note: Mounting screws are not included.

Step 1: Prepare Mounting

Attach the mounting bracket to the wall using appropriate screws and wall plugs (not supplied). Ensure the bracket is securely fastened.

Step 2: Wiring

Connect the wires from the fixture to the mains supply. The diagram shows the connection points. Use the provided heat-resistant sleeves to cover the stripped wire ends for safe connection.

Step 3: Attach Fixture

Mount the light fixture onto the prepared bracket. Ensure all connections are secure and the fixture is properly aligned.

Step 4: Final Connections

Detailed wiring and connection steps are illustrated in the diagrams. Ensure correct polarity and secure connections. The fixture is designed for direct/fixed mounting to the mains supply.

Safety and Maintenance

Electrical Safety

• IP20 Rating: This fixture is only suitable for indoor use in areas where direct contact with water cannot occur.
• Class II (Double Insulated): The lamp is double-insulated and does not require connection to an earth wire.
• Electrical Connection: The lamp is designed for direct/fixed mounting to the mains supply. In some countries, electrical installations must be carried out by a qualified electrician. Always shut off power to the circuit before starting installation.
• Wattage Limit: Do not exceed the maximum specified wattage (LED 6.2W).

Maintenance

• Cleaning: Use a soft, dry cloth for dusting. For grease or similar stains, use a soft, damp cloth. Never use detergents or chemical reagents.
• Glass Care: For mouth-blown glass, clean only when the glass is cold. Air bubbles or slight variations in glass thickness are natural consequences of the manual manufacturing process and contribute to its organic appearance.

Disposal

• WEEE Disposal: This product must not be disposed of with household waste. It should be handed over to a designated collection point for recycling of electrical and electronic equipment. Proper disposal helps prevent harm to human health and the environment. Contact your local municipality or waste disposal service for more information.

General Advice

• Keep these installation instructions for future reference.