Automotive OEM integration | CRUX Interfacing Solutions
User Manual for CRUX models including: SWRSU-38C, Radio Replacement Wiring Interface, Wiring Interface, Radio Replacement, Interface
File Info : application/pdf, 2 Pages, 1.39MB
DocumentDocumentINTERFACING SOLUTIONS R + RADIO REPLACEMENT SWC RETENTION SWRSU-38C Radio Replacement with Steering Wheel Control Retention for Select Non-Amplified Subaru Vehicles 2015 - Up PRODUCT FEATURES: - Retains select factory features in select Subaru vehicles while functioning with an aftermarket radio. - Pre-programmed to retain factory Steering Wheel Controls. - Retains StarLink functionality. - Retains factory Auxiliary Input. - Retains factory backup camera (see note on diagram below). - Includes antenna adapter. PARTS INCLUDED: SWRSU-38C Module SU-38C Harness Antenna Adapter SWC Cable INSTALLATION DIAGRAM: +12V Constant +12V ACC Ground Illuminaon (+) Antenna Turn on Reverse Trigger Right Front (+) Right Front (-) Le Front (+) Le Front (-) Right Rear (+) Right Rear (-) Le Rear (+) Le Rear (-) Yellow Red Black Orange Blue Purple/White Gray Gray/Black White White/Black Violet Violet/Black Green Green/Black Ground Audio Input (Retains Factory AUX Input) Rear View Camera Signal (Retain OE Camera) Red/White RCA Yellow RCA AFTERMARKET RADIO AFTERMARKET RADIO SELECTOR (See Page 2) SUBARU SWC SETTING (See Page 2) ON RADIO VEHICLE 12-Pin Black Connector 1 2 3 4 5 6 7 8 3.5MM SWC CABLE Plug in the 3.5MM SWC cable to the 4-pin port on the module. See "DIP SWITCH SETTINGS" section. Cap or insulate if not being used 4-Pin Connector Kenwood/JVC (BLUE / YELLOW) Insulate with tape if not being used ON RADIO VEHICLE 1 2 3 4 5 6 7 8 Connector A 28 PIN TO FACTORY HARNESS 10 PIN 6 PIN 5 PIN 5 -Pin OEM Camera Connector* ANTENNA ADAPTOR (Included in Kit) *NOTE: If the factory radio does not have a 5 pin camera connector, plug these connectors together to retain the factory backup camera. 1 of 2 Crux Interfacing Solutions · Chatsworth, CA 91311 phone: (818) 609-9299 · fax: (818) 996-8188 · www.cruxinterfacing.com rev.052821 INTERFACING SOLUTIONS R + RADIO REPLACEMENT SWC RETENTION SWRSU-38C Radio Replacement with Steering Wheel Control Retention for Select Non-Amplified Subaru Vehicles 2015 - Up STARLINK RETENTION: To retain Starlink, separate the Starlink module from the radio and reconnect the harness and antenna connectors to the module. Stuff the Starlink module back into the dash and secure it with zip ties or tape to prevent it from rattling. NOTE: The front speaker audio will be lost if the StarLink module is removed from the system. DIP SWITCH SETTINGS: AFTERMARKET RADIO DIP SWITCH SETTINGS: RADIO BRAND: DIP: 1 2 3 4 Atoto, Dual, Farenheit, Jensen, Pioneer OFF OFF ON ON Power Acoustik, Soundstream OFF OFF ON ON Blaupunkt, Most off-brand Radios OFF OFF ON ON Alpine OFF OFF OFF OFF Clarion OFF ON ON OFF Kenwood OFF ON ON ON JVC OFF ON OFF ON Boss, Old Sony OFF ON OFF OFF New Sony OFF OFF ON OFF SWC MODULE ON RADIO VEHICLE 1 2 3 4 5 6 7 8 NOTE: For Atoto, Blaupunkt, Dual, Farenheit, Power Acoustik, Soundstream, and most off-brand radios, check the aftermarket radio's manual to see if the SWC buttons need to be programmed. SUBARU STEERING WHEEL CONTROL DIP SWITCH SETTING: There are 2 possible DIP switch settings for the Subaru SWC as follows. Try the one that matches your vehicle. Subaru #1 #2 DIP: 5 6 7 8 ON OFF OFF ON OFF ON OFF ON SWC MODULE ON RADIO VEHICLE 1 2 3 4 5 6 7 8 3.5MM SWC CABLE Plug in the 3.5MM to 4-Pin SWC cable to the SWC module and the 3.5mm plug to the aftermarket radio SWC port. NOTE: Insulate the Blue/Yellow wire or 3.5mm plug if not being used. For aftermarket radios that have wires for SWC connections, cut off the 3.5mm plug on the Crux SWC Cable and connect the SWC wires as follows: Note that there are some radios that only have SWC1 and SWC2, in this case "shield" does not need to be connected. RED to SWC Key 1 WHITE to SWC Key 2 SHIELD to SWC Ground VEHICLE APPLICATIONS: SUBARU 2017 - 2020 2015 2016 - 2020 2015 - 2020 BRZ XV Crosstrek Crosstrek Forester 2016 - 2020 Impreza 2015 - 2020 Outback 2016 - 2020 WRX NOTE: For non-amplified systems only. 2 of 2 Crux Interfacing Solutions · Chatsworth, CA 91311 phone: (818) 609-9299 · fax: (818) 996-8188 · www.cruxinterfacing.com rev.052821