Phone Mount Installation Instructions
This document provides instructions for installing and using the Lectric eBikes Phone Mount.
Packing List
The following items are included in the package:
- Phone Holder
- Fixed Clamp
- Silicone Pads (6)
Parts
Identify the following parts:
- Lock Lever
- Fixed Clamp
- Joint Ball
- Nut
- Socket
- Lower Arm
- Upper Arm
- Red Switch
Installation Steps
Step 1: Attach Joint Ball to Phone Holder
Unscrew the nut. Place the nut around the joint ball. Press the joint ball into the socket on the phone holder until it securely snaps in place. Then, tighten the nut.
Step 2: Mount Fixed Clamp to Handlebars
Loosen the fixed clamp and mount it onto the handlebars. Tighten the screw and press the lever towards the fixed clamp to LOCK.
Step 3: Prepare for Phone Placement
Ensure the red switch on the back of the phone holder is set to the UNLOCK position.
Step 4: Place Phone in Holder
Use your phone to push the lower arm of the phone holder down and set your phone in place.
Step 5: Secure Phone
Click the red switch on the back to the LOCK position to secure your phone.
Notes
Adjust the silicone pads by adding or removing them, and trimming any excess material, to fit the diameter of your handlebars.
