Safety Instructions
Read these instructions carefully before operating the device and keep the document well. It is also advised to keep the receipt and the packaging well-stored.
- Protect the device against heat, direct sunlight, moisture, and sharp edges.
- Never immerse the device in liquids.
- Never touch with wet hands.
- Pull the power plug from main socket if not in use.
- Never leave the device unattended. If you leave the room, turn off the device and pull the plug out of the socket.
- When unplugging from the main socket, always pull the plug, not the cord.
- Check the blender, the plug and the cable regularly for damage. Stop using the device when damage is observed.
- Do not move the device when it is in operation.
- This device should not be used by children.
- Never put the device on a hot surface, e.g. cooker.
- Use the device only on a flat work surface.
- Packaging material, such as plastic bags, cardboard, styrofoam, etc. are not toys and should be kept away from children. There is danger of suffocation if they are reached by children.
- Turn the device on only when the lid of the jar is locked.
- Never remove the lid during operation.
Parts List
The device is equipped with a number of safety locks.
- Lid opening
- Lid
- Jar
- Rubber gasket
- Cutting unit
- Safety switch for lid
- Safety switch for jar
- The motor base
- Speed control knob
Introduction: The device will not start if the jar is not properly placed and locked on base. The device will not start if the lid on top is not properly closed and locked at the handle. Please check before contacting customer service whether these steps have been followed.
Clean Before First Use: Rinse the jar, the cutting blades and the lid in warm soapy water and dry the parts carefully before use.
Operation
The device is for mixing of food and drinks. Cut the food in pieces with maximum diameter of 1.5cm.
- Make sure the device is turned off (switch to position "0").
- Assemble the jar on the base with the jar locked.
- Add the ingredients, fluid into the jar (maximum 1250 ml).
- Close the jar with lid and make sure the lid is locked at the handle side.
- Connect the mains cables to main power supply.
- There are two mixing speeds: "1": low speed, "2": high speed.
- Turn the device off after use (switch to position "0") and unplug the power cord from the power outlet. Take the jar out of the base, and lid from jar for cleaning.
Cleaning
Warning! Be careful of the cutting blades during cleaning as they are sharp and may get injuries.
Cleaning and maintenance cannot be done by children.
- Before cleaning the device, always pull the plug from socket, and ensure that the device is cool down. Never use harsh detergent or cleaning equipment.
- Clean the motor housing with a damp cloth and dry it thoroughly.
- To clean the jar, separate it from the base and rinse all parts in warm soap water. Dry the parts thoroughly after cleaning.
Specification
| Model: | DKB350BK |
| Power supply: | 220-240VAC, 50Hz |
| Rated Power: | 350 Watt |
| Capacity: | 1.25L |
