Troubleshooting: LXJADAP Wireless Mirror Adapter Pairing Issues
If the light on the TX (Transmitter) unit continues to flash after plugging the TX/RX into the corresponding device, it indicates that the TX and RX are not paired. Please follow the steps below to re-pair the devices.
Re-Pairing Procedure
-
Prepare the TX Unit: Use a sharp tool, such as a card pin or toothpick, to insert into the small hole on the TX port. This hole contains a button. Press and hold this button for approximately 7-10 seconds. The indicator light on the TX unit will briefly disappear, signifying the reset operation. You can release the button at this point.
Image showing a hand using a card pin to press a button on the TX unit, with a red cable connected.
Image of a card pin and a SIM ejector tool.
-
Prepare the RX Unit: Use a sharp tool to insert into the small hole on the RX port, which also contains a button. Press and hold this button. While holding the button, observe the TV screen. Release the button when the following text appears on the screen: “Release the button to pair with Mate TX”.
Image showing the RX unit being connected, with the text "Release the button to pair with Mate TX" highlighted.
-
Pairing Confirmation: After the text appears on the TV screen, a QR code labeled “Ready to Pair” will be displayed. This will be followed by a “pairing…” status, and finally, “pair ok” will appear on the screen.
Note: If the QR code does not appear, please repeat steps 1 and 2.
Image a: QR code labeled "Ready to Pair" on a screen.
Image b: Screen showing "Wireless Mirror Adapter" and "Pairing..".
Image c: Screen showing "Wireless Mirror Adapter" and "Pairing OK".
Image d: Desktop view of a computer.
- Pairing Successful: Once “pair ok” is displayed, the pairing process is successful.
