Thanks for choosing VTOMAN V6 smart car jump starter. Please read the user manual carefully before use and keep it for further reference.
A. CONFIGURATIONS
The VTOMAN V6 Jump Starter features the following components:
- 1. Power switch: Used to turn the unit on/off.
- 2. Electricity indicator: Shows the remaining battery level.
- 3. Type-C Input port: For recharging the jump starter.
- 4. 5V/9V/12V Quick-charge output: For fast charging compatible devices.
- 5. 5V/2.4A output: Standard USB output for charging devices.
- 6. LED Flashlight: Features Strong, Strobe, and SOS modes.
- 7. 12V Jumper cable interface: Connection point for the included jumper cables.
- 8. Compass: Integrated compass for directional assistance.
B. ELECTRICITY INDICATORS
Press the power switch, the indicators will show electricity as follows:
| Indicators | 0 | 1 | 2 | 3 | 4 |
|---|---|---|---|---|---|
| V6 Electricity | 0% | 25% | 50% | 75% | 100% |
During charging, a blinking light indicates the charging progress. All lights will turn off when the unit is fully charged.
C. INSTRUCTIONS
Steps To Recharge The Unit
1. Connect the wall charger with the unit.
2. Plug the wall charger into your universal output socket (100-240V).
The jump starter is recharged by connecting the provided wall charger to the unit's Type-C input port and then plugging the charger into a standard electrical outlet.
Steps To Jump Start Vehicles (12V Only)
1. Plug the blue end of the jumper cable into the unit's jumper cable interface and ensure the safety indicator is off.
2. Connect the clamps to the vehicle battery: Red clamp to the positive (+) terminal, and black clamp to the negative (-) terminal.
3. Operate according to the state of the safety indicator:
- Steady Green Indicator: Connection is correct and the unit is ready for jumping start.
- Steady Red Indicator with Buzzing: The positive and negative poles are reversed. Please reconnect the clamps and wait until the indicator turns steady green.
- Flashing Green Indicator: The vehicle battery is at low voltage. Press the "BOOST" button and wait for the green light to become steady before starting the car within 30 seconds.
- No Indicator Light and No Buzzing: The vehicle battery may be completely dead. Ensure the connection is correct, press the "BOOST" button, wait for the indicator to become steady green, then start the car within 30 seconds.
4. Turn the vehicle ignition switch to the START position.
5. Remove the jumper cables after the vehicle has started.
Steps To Charge Your Electronics
1. Connect the Type-A end of your USB cable to the jump starter's quick-charge port (or 5V/2.4A output port).
2. Connect the other end of the cable to your electronic device.
3. Press the power button. The unit will automatically detect the device's battery and deliver the most suitable current for faster and safer charging.
The jump starter can charge various electronic devices like smartphones and portable media players via its USB output ports.
Steps To Switch Light Modes
Press and hold the switch button for 3 seconds to turn on the LED flashlight. Press the button repeatedly to cycle through modes: Strong, Flash, SOS, and then turn off.
D. PACKAGE CONTENT
| No. | Name | Quantity | No. | Name | Quantity |
|---|---|---|---|---|---|
| 1 | Host (Jump Starter) | 1 | 4 | User Manual | 1 |
| 2 | Jumper Cable | 1 | 5 | Storage Bag | 1 |
| 3 | Type-C USB Cable | 1 |
E. SPECIFICATIONS
Unit size: 6.69*3.25*1.34 inches
Unit weight: 0.99lb / 435g
Battery capacity: 37Wh
Output: 5V/9V/12V Quick-charge; 5V/2.4A, 12V Jumper cable interface
Input: 5V/3A Type-C input
Full charge time: 4~5 hours
Starting current: 300A (3S)
Peak current: 1500A
Operating temp: -20°C ~ 60°C / (-4°F ~ 140°F)
F. Q&A
1. How to turn off the jump starter?
The product has a smart detection function. Once there is no load, or the electronic product is fully charged, it will automatically shut down to save power.
2. How long does it take to fully recharge the V6?
Approx 4~5 hours.
3. How many times can this V6 charge a phone?
Depending on the phone's battery capacity. For example, it can charge an iPhone 8 approximately 6 times.
4. How many times can V6 start cars after a full charge?
Approx 20 times.
5. What's the service life of V6?
In normal use, it can work for 2~3 years.
6. How long can it keep charged while not using?
The V6 has a scientific circuit design. It can remain charged for 6-12 months without use, but for optimal service life, it is recommended to charge it every three months.
G. TROUBLESHOOTING
| Case | Cause | Solution |
|---|---|---|
| The V6 does not respond after pressing the power button | The circuit is cut off by self-protection due to low voltage or overheat. | Recharge the unit until at least 3 lights are lit, or let it cool down for 10 minutes until the temperature is below 55°C before using it again. |
H. TOXIC AND HAZARDOUS SUBSTANCES ILLUSTRATION
The following table shows the content of hazardous substances or elements in the product:
| Pb | Hg | Cd | Cr (VI) | PBB | PBDE |
|---|---|---|---|---|---|
| O | O | O | O | O | O |
O: The content of this hazardous substance in all homogeneous materials of the component is below the limit requirements specified in the 2002/95/EC (RoHS) standard.
I. PRECAUTIONS
- Please be cautious when using.
- Please read the instructions carefully before use.
- The product can only be used for starting 12V vehicles. It is prohibited for use on equipment such as aircrafts and ships.
- Please do not use it if the clamp or the unit has any damage.
- Prohibit using it as a car battery.
- Prohibit using it as a car battery charger.
- Please remove the unit from your car battery in time after cranking your car successfully.
- Please use the equipped jumper cables and other accessories that come with the unit only.
- Please make sure that the blue end of the jumper cable is fully inserted into the jumper cable interface; otherwise, the blue end may melt.
- Before use, ensure all battery connectors are clean and the clamps are connected correctly. If the battery poles are dirty or corrosive, the start-up performance of the product will be reduced.
- Do not use more than 3 times in a row, as it can overheat and get damaged. Let it cool down for 2 minutes after using 3 times consecutively.
- Please remove the product from the car battery within 30 seconds after use, or it may cause damage.
- Do not connect the positive and negative terminals together when the power is on.
- Please ensure that at least 3 indicator lights are lit before use.
- Please keep this product away from children.
- Do not play with the product as a toy.
- Do not expose the product to water.
- Do not immerse the product in water.
- Do not operate the product in an explosive atmosphere, such as in the presence of flammable liquids, gases, or dust.
- Do not remodel or disassemble the product. Only professional technicians are allowed to perform repairs.
- Do not expose the product to extreme heat or fire.
- To avoid the risk of short-circuiting caused by metal objects falling into the ports, please remove jewelry such as rings, bracelets, and necklaces before using the product.
- Do not drop the product. If the product is impacted or damaged, it must be tested by a qualified battery technician.
- Do not place the product in an environment where the temperature exceeds 70°C.
- Please charge at room temperature not exceeding 60°C.
- Please use only the charger delivered with the power pack to charge it.
- Do not start cars while charging the unit.
- If the host leaks, please recycle it immediately with proper equipment.
- Under extreme conditions, battery leakage may occur. If liquid comes out of the product, do not handle it directly by hand. In case of skin contact, wash immediately with soap and water. If liquid comes into contact with your eyes, rinse them with cold tap water for at least 10 minutes and seek immediate medical attention.
- Lithium-ion battery-based products should be disposed of in accordance with local regulations at the end of their life.
Customer Service
- ? 18 Months Limited Warranty Service
- ? Lifetime Technical Service
- ✉️ Feel Free to Contact Us: Support@vtoman.com
- ? For FAQ and More Information: Support@vtoman.com
Made in China
Compliance Marks: UKCA, CE, FC, RoHS, Recycling Symbol [♻️], WEEE Symbol [♺]
