Handheld Controller for Switch

Controller Diagram

The diagram illustrates the layout of the Retroflag Handheld Controller for Switch. It shows two connection options for the Switch console: "Switch" and "Switch OLED model". The controller itself features: On the left side: ZL, L, Left Stick, L3, D-pad, Screenshot, Turbo/Swap, Motion Control. On the right side: ZR, R, A, B, X, Y buttons, Right Stick, R3, Home button. A USB-C port is located at the bottom, labeled "PD Fast Charger Compatibility", with an [arrow] indicating connection to the Switch console. Additional notes state: "HD rumble, IR camera, NFC scanning, and wake up Switch console are not supported."

Turbo and Swap Buttons

Supported buttons: A, B, X, Y, L, R, ZL, ZR, L3, R3

Turbo Function

Press and hold the TURBO button, then press the button you would like to set Turbo. The controller vibrates when Turbo is activated.

Auto-Turbo Function

Press and hold the TURBO button, then double press the button you would like to set Auto-Turbo. Pause/Restart Auto-Turbo function via press the button you set. The controller vibrates twice when Auto-Turbo is activated.

Swap Buttons Function

Press and hold the two buttons you would like to swap, then press the TURBO button. The controller vibrates when Button Swap is successful.

Deactivate Turbo / Auto-Turbo / Swap Functions

Press and hold the TURBO button, then press the activated button. The controller vibrates when the cancellation is successful. * Can't set Turbo and Swap functions on one button at the same time.

System Requirements and Notes

• Switch needs to be 3.0.0 or above. Go to System Setting – Controller and Sensors – turn on Pro Controller Wired Communication.
• The USB port can charge only when the Switch console is connected.