Instructions for RAB models including: High Bay Series LED High-Low Bay Fixtures, High Bay Series, LED High-Low Bay Fixtures, High-Low Bay Fixtures, Low Bay Fixtures, Bay Fixtures, Fixtures
Hid Replacements 1300-20000 Lumens Hid Field Adjustable Selectabl | Crescent Electric Supply Company
RAB Lighting HIDFA-135S-V-EX39-8CCT-BYP LED HID High Bay Retrofit Lamp, EX39 Base, 3K/4K/5K, 1,300 Thru 20,000 Lm, 120-277V | Graybar Store
-20°C to 45°C (-4°F to 113°F) THIS DEVICE IS NOT INTENDED FOR USE WITH EMERGENCY EXITS. Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation. Please examine all parts that are not intended to be replaced by the retrofit kit for damage and replace any damaged parts prior to installation of the retrofit kit. THE RETROFIT KIT IS ACCEPTED AS A COMPONENT OF A LUMINAIRE WHERE THE SUITABILITY OF THE COMBINATION SHALL BE ETERMINED BY AUTHORITIES HAVING JURISDICTION. PRODUCT MUST BE INSTALLED BY A QUALIFIED ELECTRICIAN IN ACCORDANCE WITH THE APPLICABLE AND APPROPRIATE ELECTRICAL CODES. THE INSTALLATION GUIDE DOES NOT SUPERSEDE LOCAL OR NATIONAL REGULATIONS FOR ELECTRICAL INSTALLATIONS. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help. Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Straighten one end of the keychain and penetrate it from any direction between the four pillars of the drive box, and nest 2 pillars continuously, and the safety rope is inserted into the keychain to form a closed loop. Flip the color switch to the desired position before installation. Dial and rotate the dimmer knob to adjust to the required luminous flux position before installation. 4 4 Fig 4 7 7/8" 2021 Cranbury, New Jersey 08512 USA HB SERIES-IN-0621 12 5/8"Adobe PDF library 16.03