HP Product Notice
This document provides country- and region-specific non-wireless and wireless regulatory notices and compliance information for your product. Some of these notices may not apply to your product.
Safety Notice
1. Keep the device and packaging materials out of the reach of infants and children.
2. Avoid subjecting the PCB board to splashing water.
3. Keep the device away from any liquid and chemicals.
4. Keep your device away from all flames, such as candles.
5. Avoid places where water is never waterproof.
6. If water enters the product, tilt it immediately so that the water does not flow back into the PCB board position and avoid prolonged exposure inside the product.
7. Handle the product with care. Avoid contact with sharp objects.
8. Do not drop or disassemble the product, otherwise the warranty will be void. Opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to an authorized service center.
9. Both the product and user's manual are subject to further updates, modifications, or supplements without further notice.
Product Certification
FCC Certificate of Compliance
[FCC Certified] Authorized under Declaration of Conformity according to 47 CFR, Part 2 and Part 15 of the FCC Rules. The product listed was tested in the BTL EMC Laboratory to comply with the criteria limits Class B of conducted and radiated emissions of the Technical Standards FCC Part 15, Subpart B, established by the FCC, USA.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
CE Certificate of Compliance
[CE Marked] This is to certify that the product listed was tested in the BTL EMC Laboratory to comply with the required criteria levels of the Generic Standards or Product Family Standard(s) and/or Basic Standard(s) based on the essential conformity requirements of EMC Directive 2014/30/EU.
KCC Certificate of Compliance
[KCC Certified] It is verified that the foregoing equipment has been registered under clause 3, article 58-2 of the radio waves act.
RoHS Certificate of Compliance
[RoHS Compliant] This certificate of compliance is based on a test procedure or an evaluation of the above-mentioned product. This is to certify that the above-mentioned product is in compliance with the RoHS Directive (2011/65/EU) of the European Parliament. It is only valid in connection with the test report.
BSMI Restricted Substances
[BSMI Restricted Substances Symbol]
Hazardous Substances
The following table lists the name and content of hazardous substances in the product, compiled according to SJ/T 11364.
| Unit | Lead (Pb) | Mercury (Hg) | Cadmium (Cd) | Hexavalent Chromium (Cr+6) | Polybrominated Biphenyls (PBB) | Polybrominated Diphenyl Ethers (PBDE) |
|---|---|---|---|---|---|---|
| Plastic parts | More than 0.1wt% | ○ | ○ | ○ | ○ | ○ |
| Metal parts | More than 0.1wt% | ○ | ○ | ○ | ○ | ○ |
| Circuit board assembly | More than 0.1wt% | ○ | ○ | ○ | ○ | ○ |
| Cable | More than 0.1wt% | ○ | ○ | ○ | ○ | ○ |
Note 1: "Exceeding 0.1 wt%" and "exceeding 0.01wt%" indicate that the percentage content of the restricted substance exceeds the reference percentage value of the presence condition.
Note 2: "○" indicates that the percentage content of the restricted substance does not exceed the reference percentage value of presence.
Note 3: The "-" indicates that the restricted substance corresponds to the exemption.
Note X: Indicates that the content of this hazardous substance in at least one homogeneous material of this part exceeds the limit requirement of GB/T 26572.
Environment-friendly Use Period
[10-year eco-friendly use period icon] According to the Electronic Information Products Pollution Control Regulations of the People's Republic of China, this mark is required on products sold in the People's Republic of China. The number within the mark stands for the environmental usage lifetime under normal usage.
Laser Compliance
[Class 1 Laser Symbol] A mouse may contain a laser that is classified as Class 1 Laser. Product in accordance with US FDA regulations and the IEC 60825-1. The product does not emit hazardous laser radiation. Each laser product complies with 21 CFR 1040.10 and 1040.11, except for deviations pursuant to Laser Notice No.50, dated June24, 2007; and with IEC 60825-1:2007.
Warning
[Warning Icon] Use of controls or adjustments or performance of procedures other than those specified herein or in the laser product's installation guide may result in hazardous radiation exposure. To reduce the risk of exposure to hazardous radiation:
- Do not try to open the module enclosure. There are no user serviceable components inside.
- Do not operate controls, make adjustments, or perform procedures to the laser device other than those specified herein.
- Allow only HP Authorized service technicians to repair the unit.
Headset and Earphone Volume Level Notice
[Headset Volume Notice Icon] To prevent possible hearing damage, do not use high volume levels for long periods. Before using a headset or earphones, always reset the volume to a low level. For your own safety, use headsets or earphones compliant with the headphone limits in EN 50332-2.
Environmental Notices
Electronic Hardware Recycling
[Recycling Symbol] HP encourages customers to recycle used electronic hardware. For more information about recycling programs, see the HP website at http://www.hp.com/recycle.
Disposal of Waste Equipment
[Do Not Dispose with Household Waste Icon] This symbol means do not dispose of your product with your other household waste. Instead, you should protect human health and the environment by handing over your waste equipment to a designated collection point for the recycling of waste electrical and electronic equipment. For more information, please contact your household waste disposal service or go to http://www.hp.com/re-cycle.
