Simplifying embedded vision for all. - Arducam
GitHub - ArduCAM/PCA9685: This library is used for Arducam Pan Tilt Camera for Raspberry Pi
User Guide for ArduCam models including: B0399B0283 Pan-Tilt Kit, B0399B0283, Pan-Tilt Kit
64MP Camera & Pan-Tilt Kit
File Info : application/pdf, 5 Pages, 3.48MB
DocumentDocumentPan-Tilt Kit for Raspberry Pi Cameras Getting Started SKUB0399B0283 Published in June 2022 by ARDUCAM TECHNOLOGY CO., LIMITED Packing List ×1 ×1 ×1 ×1 ×10 ×2 ×1 ×1 ×4 ×5 ×1 Installation The kit is compatible with the official camera module V1, V2, HQ and Arducam Pi cameras with same form factors. Keep the servo arms in the original position so no further calibration is required. Turn off your Raspberry Pi and disconnect the power supply. 1. Install the controller board. M2×4mm 2. Install the pre-assembled pan servo. M2×6mm 1 Pan-Tilt Kit for Raspberry Pi Cameras M2×6mm M2×6mm Installation 3. Install the pre-assembled tilt servo. M2×6mm 4. Connect the servos to the controller board. Back view L B R W R W R B L R NOTE: Pls make sure the wires to the servo are correctly connected. Top view 5. Connect the pan-tilt kit to your Raspberry Pi. Follow the servo motors' wire colors but not the jumper wires'. The colors of the jumper wires are used to distinguish between each other only and do not need to be matched in real wire connection to the Raspberry Pi. 2 Pan-Tilt Kit for Raspberry Pi Cameras Operating the Pan-Tilt Kit 1. Clone demo code git clone https://github.com/ArduCAM/PCA9685.git 2. Enter the target directory cd PCA9685/ 3. Compile the code make 4. Run the demo sudo ./RunServoDem Use the arrow keys on the keyboard to control the camera pan and tilt direction. 3 Pan-Tilt Kit for Raspberry Pi Cameras Raspberry Pi and the Raspberry Pi logo are trademarks of the Raspberry Pi Foundation www.arducam.com