User Manual for align models including: 2ARGX-NGAP, 2ARGXNGAP, AP7633-USB NGAP WiFi USB Router, AP7633-USB, NGAP WiFi USB Router
Align Technology Inc. NGAP WiFi USB Router 2ARGX-NGAP 2ARGXNGAP ngap
AP7633-USB User manual 1 Setting for first use · Goto internet setting · Goto change interface card setting 2 Find Into "content" setting 3 · Into TCP/IP setting 1 2 4 · Use static IP address 192.168.1.2~255 · Mask: 255.255.255.0 5 · Use internet browser and goto address "192.168.1.1" into main setting page · For first use, just press "Login" 1 2 6 · Main setting page 7 1 2 · Press "network", then "Wireless" 8 · Choose this item "MediaTek MT76x2E deivice, then press "Scan" · If it takes a lot of time to scan, you can press "Restart" to restart AP7633USB device and scan again. 9 · Choose one available AP, then press "Join Network" 10 · Fill in the password for the chosen AP, then press "Submit" 1 2 11 · Press "Save" 12 · Press "Save & Apply", then the chosen AP will be shown up on the bottom of this page 2 1 13 Change user's name and password 1 · Into "System", "Administration" 2 item 14 · Set new password, then "Save" 15 · Quit and re-into "192.168.1.1" setting page, you will need fill in the new password. 16 Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. FCC Caution: To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. (Example - use only shielded interface cables when connecting to computer or peripheral devices). FCC Radiation Exposure Statement This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. FCC Compliance Statement: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2)this device must accept any interference received, including interference that may cause undesired operation. This device must accept any interference received, including interference that may cause undesired operation. Product that is a radio transmitter is labeled with FCC ID. 17 Industry Canada Statement This device complies with Industry Canada licence-exempt RSS standard. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. IC Radiation Exposure Statement: This equipment complies with IC RSS-102 radiation exposure limit set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 0.5cm between the radiator and your body. Cet équipement est conforme aux CNR-102 d'Industrie Canada. Cet équipement doit êtreinstallé et utilisé avec une distance minimale de 20 centimètres entre le radiateur et votrecorps. Cet émetteur ne doit pas être co-localisées ou opérant en conjonction avec autreantenne ou émetteur. Les antennes utilisées pour cet émetteur doivent être installés etfournir une distance de séparation d'au moins 20 centimètre de toute personne et doit pas être co-située ni fonctionner en conjonction avec une autre antenne ou émetteur. 18Adobe PDF Library 23.3.247