Installation Guide for Schreder models including: CLB1, CLB1 Circle LED Base for Hestia MIDI, Circle LED Base for Hestia MIDI, LED Base for Hestia MIDI, Hestia MIDI, MIDI
Sustainable lighting: CIRCLE LED BASE for easy luminaire retrofitting | Schréder
Schreder-CLB HESTIA MIDI-Installation Instructions-RevA | Schréder Corporate
File Info : application/pdf, 3 Pages, 2.25MB
DocumentDocument86mm Copyright © Schréder S.A. 2024 - Executive Publisher: Stéphane Halleux - B-4000 Liége, Rue de Mons 3 (Belgium) - The information, descriptions and illustrations herein are only of an indicative nature and subject to changes without notice. CIRCLE LED BASE 1&2 for HESTIA MIDI ENG INSTALLATION INSTRUCTIONS DEU INSTALLATIONSANLEITUNG FRA INSTRUCTIONS DE MONTAGE SRP UPUTSTVA ZA INSTALACIJU ITA POL SPA ARA ISTRUZIONI DI INSTALLAZIONE INSTRUKCJE MONTAU INSTRUCCIONES DE INSTALACIÓN NLD RUS POR INSTALLATIE INSTRUCTIES DAN INSTALLATIONSVEJLEDNING RON INSTRUCIUNI DE INSTALARE INSTRUÇÕES DE INSTALAÇÃO SWE INSTALLATIONSANVISNING HUN TELEPÍTÉSI ÚTMUTATÓ CHI UKR All the tightening torques values are given for assemblies without the addition of a grease decreasing friction. 13 Silicone sealant PZ2 HESTIA MIDI WITH CLB1* 625mm 132mm 257mm 182mm 185.7mm 236mm 83mm *CLB2 is also available for HESTIA MIDI, with the same adaptation plate size dimensions (only the cut-out being different) 03-77-297 | rev A | 04-2024 www.schreder.com 1/3 1 2 Disconnect the luminaire from network and clean the surface 3 Open the luminaire for gear compartment and light source access 4 Copyright © Schréder S.A. 2024 - Executive Publisher: Stéphane Halleux - B-4000 Liége, Rue de Mons 3 (Belgium) - The information, descriptions and illustrations herein are only of an indicative nature and subject to changes without notice. Disconnect mains 5 Disconnect HID cables 6 PZ2 4xM5 4xM5 Remove screws holding the optical compartment. KEEP THESE FOR LATER USE! Remove optical compartment 7 8 13 2xM8 Remove optical compartment connection to gearplate Remove gearplate 03-77-297 | rev A | 04-2024 www.schreder.com 2/3 Copyright © Schréder S.A. 2024 - Executive Publisher: Stéphane Halleux - B-4000 Liége, Rue de Mons 3 (Belgium) - The information, descriptions and illustrations herein are only of an indicative nature and subject to changes without notice. 9 10 Use silicone sealant in the sealing groove and place CLB adaptation plate into the luminaire Fix the adaptation plate into position in the luminaire body with the clamps provided and the screws previously removed 11 12 PZ2 b. a. 4xM5 PZ2 1xM5 Fasten the adaptation plate and clamps with the screws (tightening torque: 2Nm) a. Connect earthing cable of the adaptation plate to luminaire body b. Connect mains cable to CLB unit 13 14 Close the lock on the bottom side of the luminaire Connect the assembly back on network 03-77-297 | rev A | 04-2024 www.schreder.com 3/3