Built-in SXS Non-Dispensing Quick Start Guide

Operating Instructions

IMPORTANT: Before operating this appliance, ensure it has been properly installed according to the appliance's Owner's Manual. The Temperature Control UI is located inside the appliance above the crisper drawers.

For convenience, your refrigerator and freezer temperature controls are set to recommended set points at the factory. Upon initial installation, verify that the temperature controls are still set to these recommended points: 37°F (3°C) for the refrigerator and 0°F (-18°C) for the freezer.

Important Notes

The recommended settings are suitable for normal household refrigerator use. The controls are correctly set when milk or juice is as cold as desired and ice cream is firm.
Areas with higher humidity or extreme temperatures (e.g., garages, basements, porches) may require temperature adjustments away from the recommended settings.
When the power is on, the temperature display shows the set point temperature of the compartment.
Wait 24 hours for the refrigerator to cool completely before adding food to prevent spoilage.
Adjusting controls to colder settings will not cool compartments faster.
If the temperature is too warm or too cold, check that air vents are not blocked before adjusting controls.
Allow at least 24 hours between temperature adjustments and recheck temperatures before making further changes.

Setting the Temperature (°F / °C)

Press the °F - °C button to switch between Celsius and Fahrenheit. The selected temperature option displays when activated, and the LED is off when deactivated.

Adjusting Temperature

The following applies to both refrigerator and freezer temperature buttons:

Pressing the Freezer or Refrigerator picture button once decreases the digit by 1.
Once the lowest temperature for a zone is reached, the next button press cycles to the highest temperature allowed for that zone.

Temperature Ranges:

Refrigerator: 36°F to 43°F (2°C to 6°C), factory default 37.4°F (3°C).
Freezer: -9°F to -3°F (-23°C to -16°C), factory default -0.4°F (-18°C).

Temperature Adjustment Guide

Condition/Reason	Temperature Adjustment
REFRIGERATOR too cold	REFRIGERATOR Control 1° higher
REFRIGERATOR too warm	REFRIGERATOR Control 1° lower
FREEZER too cold	FREEZER Control 1° higher
FREEZER too warm/too little ice	FREEZER Control 1° lower

Special Features

Max Cool / Max Freeze

Max Cool: Assists with periods of high refrigerator use, full grocery loads, or temporarily warm room temperatures. Press Max Cool to set the freezer and refrigerator to their lowest temperature settings. Press again to return to normal settings. Max Cool automatically shuts off in approximately 12 hours. Changing the refrigerator temperature while Max Cool is active will deactivate it.

Max Freeze: Increases ice production for temporary periods of heavy ice use. Press Max Freeze to set the freezer to its lowest temperature setting. Press again to return to normal settings. Max Freeze automatically shuts off in approximately 48 hours. Changing the freezer temperature while Max Freeze is active will deactivate it.

Note: Activating Vacation Mode while Max Cool is ON will deactivate Max Cool.

Alarm Functions

Door Open Alarm

The Door Ajar Alarm sounds if the refrigerator or freezer door is open for 5 minutes while cooling is active. The alarm repeats every 2 minutes. Close both doors to silence it. The feature resets and will reactivate if a door is left open for 5 minutes again.

Power Outage Indicator

This indicator alerts you if the refrigerator's power supply was interrupted and the freezer temperature rose to 18°F (-8°C) or higher. When power is restored, the button flashes, and a red Power Outage icon appears. While active, all other control and dispenser functions are disabled until you acknowledge the outage by pressing the 'Measured Fill' button to reset the display.

Miscellaneous

Crisper Menu

There are 4 preset temperatures for the Crisper Menu. Press the crisper menu button to select the desired option.

Control Lock

Press and hold the [Crisper] button for approximately 5 seconds. The lock indicator will blink twice and emit a tone, remaining on/off. When Control Lock is active, other functions are inaccessible. Pressing any button will produce an invalid tone and the lock indicator will blink three times. Water/Ice paddles are also disabled.

Showroom Mode

This mode is for sales floor demonstrations. Press and hold the [RC Temp] + [FC Temp] buttons for 5 seconds; the showroom indicator will blink twice and remain on/off.

Water Filter Indicator and Reset

The water filter indicator on the control panel helps you know when to change the water filter.

Replace status: The water filter status display indicates it's almost time to change the filter cartridge.
Replace Overdue status: A red light on the control panel signifies it's time to change the filter cartridge.

It is recommended to replace the filter when the status light turns red or water flow noticeably decreases. Change the filter sooner if water flow diminishes. The filter should be replaced at least every 6 months, depending on water quality and usage.

When dispensing water after the 'Replace Filter' icon is on, the icon blinks during dispensing. This applies to both 'Replace Filter' and 'Replace Overdue' states. Fourteen days after the 'Replace Filter' indicator turns on, it enters 'Replace Overdue' mode.

Filter Reset

After replacing the filter, press and hold the Filter Reset button for 3 seconds. The button will no longer display once reset. Refer to the Owner's Manual's "Water Filtration System" section for filter removal and replacement steps.

Online Ordering Information

For detailed installation instructions, maintenance information, winter storage, and transportation tips, please consult the Owner's Manual included with your appliance.

For information on the full cycle guide, warranty, detailed product dimensions, or complete instructions for use and installation, please visit:

United States: https://www.kitchenaid.com/service-and-support
Canada: https://www.kitchenaid.ca/service-and-support

This may help save the cost of a service call. For further assistance, use the contact information below:

United States:

1-800-253-1301
KitchenAid Brand Home Appliances
Customer Experience Center
553 Benson Road
Benton Harbor, MI 49022-2692

Canada:

1-800-807-6777
KitchenAid Brand Home Appliances
Customer Experience Centre
200-6750 Century Ave.
Mississauga, Ontario L5N 0B7

To purchase additional bakeware, please visit: https://www.kitchenaid.com/kitchenware/bakeware

Get started with your built-in refrigerator. Scan the QR code to see top features, tips, and how-to videos.

	KitchenAid Built-in SXS Non-Dispensing Refrigerator Quick Start Guide This guide provides essential operating instructions for the KitchenAid Built-in Side-by-Side Non-Dispensing Refrigerator, covering temperature control, cooling modes, alarm functions, water filter management, and support information.
	KitchenAid SXS Dispensing Refrigerator Quick Start Guide A quick start guide for the KitchenAid SXS Dispensing Refrigerator, covering operating instructions, temperature settings, water filter replacement, and special modes like Max Cool, Max Freeze, and Sabbath Mode.
	KitchenAid Side-by-Side Refrigerator Quick Start Guide A quick start guide for KitchenAid side-by-side refrigerators, covering operating instructions, temperature settings, special modes like Sabbath Mode and Max Cool, power outage indicators, and door ajar alarms.
	KitchenAid French Door Bottom Refrigerator Quick Start Guide A quick start guide for operating and setting up a KitchenAid French Door Bottom Refrigerator, including temperature controls, special features like Max Cool and Extend-Freeze, and water filter status.
	KitchenAid French Door Bottom Mount Refrigerator Quick Start Guide A concise guide for operating and setting up your KitchenAid French Door Bottom Mount refrigerator, covering temperature controls, alarms, user preferences, and maintenance information.
	KitchenAid French Door Bottom Mount Refrigerator Quick Start Guide Concise guide for setting up and operating your KitchenAid French Door Bottom Mount Refrigerator, covering temperature controls, alarms, humidity, water filter, and special features.
	KitchenAid French Door Refrigerator Quick Start Guide A quick start guide for operating and adjusting the settings of a KitchenAid French Door Bottom Mount Refrigerator, including temperature controls, special features like Max Ice and Max Cool, and alarm functions.
	KitchenAid French Door Bottom Mount Refrigerator Quick Start Guide & Operating Instructions Get started quickly with your KitchenAid French Door Bottom Mount refrigerator. This guide covers temperature controls, special features like Temp Alarm and Max Ice, user preferences, and support information.