Step 1: Connection
Connect the Shine WiFi module to the inverter's WiFi/GPRS port.
Step 2: Status Check
Turn on the inverter. Observe the LED indicators on the Shine WiFi module to confirm communication status:
- Red LED flashing: Inverter and Shine WiFi communication is normal.
- Green LED flashing: Shine WiFi, inverter, and router communication is established.
- Blue LED flashing: Shine WiFi, inverter, router, and ShineServer communication is successful.
Step 3: Registration and Device Addition
Download and install the ShinePhone app from your mobile app store. Follow these steps:
- Connect your mobile phone to the same WiFi network the Shine WiFi module will use. Ensure the router name uses English letters and numbers only and is securely encrypted.
- Open the ShinePhone app and register a new account or log in.
- Select your country and city.
- Fill in the required user information and proceed to the "Add datalogger" page.
- Scan the Shine WiFi module's barcode or enter its serial number (SN) and checkcode.
- Configure your home WiFi network name (SSID) and password.
- Upon successful configuration, the blue LED on the Shine WiFi module will flash, indicating connection to the Growatt ShineServer.
For detailed information on adding, editing, or deleting dataloggers, refer to the app's interface.
For further assistance, visit server.growatt.com.
Step 4: Reset to Factory Settings
If your home router details change (password or network), reset the Shine WiFi module. Remove the rubber plug and press the KEY button for 6 seconds until all LEDs light up. Then, reconfigure the module through the ShinePhone app.
Troubleshooting
Refer to the table below for common LED states and their corresponding indications and troubleshooting steps.
| LED State | Indication | Troubleshooting |
|---|---|---|
| All three LEDs are dark | Datalogger not connected well with inverter WiFi/GPRS port | Check if the DIP switch beside inverter's WiFi/GPRS port is switched to "ON". |
| Only Red LED flashes | ShineWiFi and inverter communication is OK | Check router information: name (English letters/numbers only), encrypted network, no secondary authentication. Verify correct WiFi name and password entered during configuration. |
| Only Green LED flashes | ShineWiFi, inverter, and router communication is OK | Check if the home router is connected to the internet. Verify router firewall allows ports 5279 and 5280. |
| Only Blue LED flashes | ShineWiFi, inverter, router, and ShineServer communication is OK | Normal working state. |
| Red LED always ON | ShineWiFi module error | Replace with a new Shine WiFi module. |
| Green LED always ON | ShineWiFi module in switching mode | No response if you press the KEY button during this period. |
| Blue LED always ON | ShineWiFi module is in AP mode | Debug mode, short press the KEY button to quit. |
Appendix A: Shine WiFi KEY Button Description
Details on the function of the KEY button for different operations:
- Power on, press KEY button: ShineWiFi enters AP mode (debug mode).
- In AP mode, press KEY button: Quit AP mode.
- Long press KEY button for >6 sec: Reset ShineWiFi to Factory settings.
Growatt | Global Leading Distributed Energy Solution Provider
