Ego Compressor

Wampler Pedals

Built in USA

Product Overview

From silky smooth sustain to full out country chickin' pickin' territory, the Wampler Ego Compressor is the most versatile compressor pedal on the market...

Controls

Volume

Controls the total output volume.

Attack

Controls how quickly the compression action starts to take effect. Note that the more clean signal used with the "blend" control, the less effect this will have.

Blend

Allows you to mix the clean signal with the compressed signal. 100% clean is all the way counterclockwise, 100% compressed is all the way clockwise.

Tone

Controls the amount of presence in the compressed signal only. This has no effect on the clean signal controlled by the "blend" control.

Sustain

Controls the amount of sustain and compression. Note that the more clean signal used with the "blend" control, the less effect this will have.

Power Requirements

This pedal was designed around the usage of a 9v or 18vDC power source and is intended to sound its best at 9V. To avoid damage to the pedal, do not exceed 18VDC, do not use center pin positive adapters and do not use AC power. Using an incorrect power adapter can lead to damage and will void the warranty on the pedal. This pedal draws 14mA at 9Vdc.

Warranty Information

WAMPLER Pedals Limited Warranty

WAMPLER offers a five (5) year warranty to the original purchaser that this WAMPLER product will be free from defects in material and workmanship. A dated sales receipt will establish coverage under this warranty. This warranty does not cover service or parts to repair damage caused by accident, neglect, normal cosmetic wear, disaster, misuse, abuse, negligence, inadequate packing or shipping procedures and service, repair or modifications to the product, which have not been authorized or approved by WAMPLER. If this product is defective in materials or workmanship as warranted above, your sole remedy shall be repair or replacement as provided below.

Return Procedures

In the unlikely event that a defect should occur, follow the procedure outlined below. Defective products must be shipped, together with a dated sales receipt, freight pre-paid and insured directly to WAMPLER SERVICE DEPT - 5300 Harbor Street, Commerce, CA 90040. A Return Authorization Number must be obtained from our Customer Service Department prior to shipping the product. Products must be shipped in their original packaging or its equivalent; in any case, the risk of loss or damage in transit is to be borne by the purchaser. The Return Authorization Number must appear in large print directly below the shipping address. Always include a brief description of the defect, along with your correct return address and telephone number.

When emailing to inquire about a returned product, always refer to the Return Authorization Number. If WAMPLER determines that the unit was defective in materials or workmanship at any time during the warranty period, WAMPLER has the option of repairing or replacing the product at no additional charge, except as set forth below. All replaced parts become a property of WAMPLER. Products replaced or repaired under this warranty will be returned via ground shipping within the United States-freight prepaid. WAMPLER is not responsible for costs associated with expedited shipping, either to WAMPLER or the return of the product to the customer.

Incidental or Consequential Damage

In no event is WAMPLER liable for any incidental or consequential damages arising out of the use or inability to use of any WAMPLER product, even if WAMPLER or a WAMPLER dealer has been advised of the possibility of such damages, or any other claim by any other party. Some states do not allow the exclusion or limitation of consequential damages, so the above limitation and exclusion may not apply to you. This warranty gives you specific legal rights and you may also have other rights which may vary from state to state.

For Your Protection

Please complete the online warranty registration within (10) ten days of the date of purchase so that we may contact you directly in the event a safety notification issued in accordance with the 1972 Consumer Product Safety Act.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/ TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Customer Support

Our dedicated staff is ready to help you with any warranty or product questions - please email us at help@wamplerpedals.com or call us at (765) 352-8626.

Please remember to register your pedal as soon as possible after purchase at the following web page to ensure quicker service if you should ever need to make a warranty claim: www.RegisterYourWampler.com

For a more in depth manual visit: www.wamplerpedals.com/downloads/

Connect With Us

[Instagram] @Wamplerpedals

[Twitter] @Wamplerpedals

[Facebook] /Wamplerpedals

[YouTube] youtube.com/user/wampcat

Website: www.wamplerpedals.com

	Wampler Belle Overdrive Guitar Pedal - Overview and Controls Learn about the Wampler Belle Overdrive, a classic low-gain overdrive guitar pedal. This guide covers its controls, power requirements, warranty, and support information.
	Wampler Paisley Drive Guitar Pedal Manual & Specifications Official manual and specifications for the Wampler Paisley Drive guitar pedal, designed with Brad Paisley. Features include control explanations, power requirements, warranty, and support information.
	Wampler Pinnacle Deluxe V2 Guitar Pedal - User Manual and Specifications Detailed information on the Wampler Pinnacle Deluxe V2 guitar distortion pedal, including controls, operation, power requirements, warranty, return procedures, FCC compliance, and customer support.
	Wampler Phenom Distortion: Quick Reference Guide & Warranty Information Discover the Wampler Phenom Distortion guitar pedal. This guide provides details on its features, controls, operation, warranty, and customer support, ensuring you get the best performance from your gear.
	Wampler Ratsbane Distortion Pedal User Manual and Specifications Detailed guide to the Wampler Ratsbane Distortion guitar effects pedal, covering its controls, power requirements, warranty information, return procedures, and customer support contacts.
	Wampler Pantheon Overdrive Pedal: Features, Settings, and Warranty Explore the Wampler Pantheon Overdrive, a classic-inspired guitar pedal. Learn about its features, gain stages, overdrive voices, suggested settings, and warranty information.
	Wampler Velvet Fuzz Guitar Pedal: Features, Operation, and Warranty Explore the Wampler Velvet Fuzz, a versatile guitar pedal offering creamy, smooth, or aggressive fuzz tones. This guide details its controls (Volume, Brightness, Fuzz, Big/Tight Toggle), power requirements, FCC compliance, and the Wampler 5-year limited warranty.
	Wampler Ethereal Reverb and Delay Pedal Manual Explore the Wampler Ethereal, a high-quality reverb and double-layered delay pedal. This manual provides detailed information on its features, controls, and warranty.